Sunbeam TAP0002WH Rise Up 2 Slice Toaster User Guide
- June 9, 2024
- Sunbeam
Table of Contents
Sunbeam TAP0002WH Rise Up 2 Slice Toaster
Important instructions retain for future use.
Sunbeam’s Safety Precautions
SAFETY PRECAUTIONS FOR YOUR SUNBEAM TOASTER.
- Do not place any objects such as toast, bread or similar on top of your toaster when in use.
- Operate the toaster on a flat level surface.
- The bread may burn, therefore do not use the toaster near or below combustible material, such as curtains.
- Do not leave your toaster unattended when in use.
- Clean crumb tray regularly.
- Do not allow crumbs to accumulate in the crumb tray.
- Do not toast stale bread, rice crackers or similar on a high setting as they may catch fire.
- WARNING: Never attempt to extract jammed toast, crumpets or muffins with a knife or any other metal object, as contact with a live element may cause electrocution.
Sunbeam is very safety conscious when designing and manufacturing consumer products, but it is essential that the product user also exercise care when using an electrical appliance. Listed below are precautions which are essential for the safe use of an electrical appliance:
- Read carefully and save all the instructions provided with an appliance.
- Always turn the power off at the power outlet before you insert or remove a plug. Remove by grasping the plug – do not pull on the cord.
- Turn the power off and remove the plug when the appliance is not in use and before cleaning.
- Do not use your appliance with an extension cord unless this cord has been checked and tested by a qualified technician or service person.
- Always use your appliance from a power outlet of the voltage (A.C. only) marked on the appliance.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the appliance.
- The temperature of accessible surfaces may be high when the appliance is operating.
- Never leave an appliance unattended while in use.
- Do not use an appliance for any purpose other than its intended use.
- Do not place an appliance on or near a hot gas flame, electric element or on a heated oven.
- Do not place on top of any other appliance.
- Do not let the power cord of an appliance hang over the edge of a table or bench top or touch any hot surface.
- Do not operate any electrical appliance with a damaged cord or after the appliance has been damaged in any manner. If damage is suspected, return the appliance to the nearest Sunbeam Appointed Service Centre for examination, repair or adjustment.
- For additional protection, Sunbeam recommend the use of a residual current device (RCD) with a tripping current not exceeding 30mA in the electrical circuit supplying power to your appliances.
- Do not immerse the appliance in water or any other liquid unless recommended.
- Appliances are not intended to be operated by means of an external timer or separate remote control system.
- This appliance is intended to be used in household and similar applications such as: staff kitchen areas in shops, offices and other working environments; farm houses; by clients in hotels, motels and other residential type environments; bed and breakfast type environments.
If you have any concerns regarding the performance and use of your appliance, please visit www.sunbeam.com.au or contact the Sunbeam Consumer Service Line. Ensure the above safety precautions are understood.
Features of your Rise Up Toaster
- Self-centering bread slots
- High-lift and Toasting lever
- Defrost button
- Reheat button
- Cancel
- Browning control dial
- Removable crumb tray
Using your Rise Up Toaster
Plug the toaster into a 230-240 volt AC power outlet and switch the power on.
Toasting Bread
-
Position the bread into the bread slot.
-
Select the desired browning setting using the Browning Control.
Note: If toasting 1 slice it is recommended that you use a lower browning setting to achieve your required result and to prevent burning.
Important: Do not toast stale bread, rice crackers or similar on a high setting as there is a chance that they may catch fire. -
Push the Toasting Lever down to commence the toasting cycle.
-
When the desired browning is achieved, the toaster will automatically stop toasting and pop the toast up.
-
If you need to remove the toast before the cycle is complete, press the Cancel button and the toast will pop up.
-
To remove small pieces of toast, crumpets or bagels, use the High-lift Lever to lift the toast above the starting position. This will prevent burning your fingers as you remove the toast.
-
When toasting only one piece in your Long Slot 4 slice toaster, position the bread in the middle of the bread slot. When toasting two pieces in your 4 slice toaster, position one piece in the center of each slot.
Hot Surface Do Not Touch
This symbol indicates that the temperature of accessible surfaces may be high when the appliance is operating and for some time after use.
Toaster Functions
Cancel button
The Cancel button immediately interrupts any toasting cycle and pops the toast
up.
Reheat button
Simply press the toasting lever down, then press the reheat button to start
the reheat cycle.
Defrost button
The Defrost setting ensures bread can be toasted straight from the freezer.
The color of your toast will brown according to the browning setting you have
chosen.
High-lift Lever
Raises the toast above the starting position so you can remove the toast from
the toaster without burning your fingers. Ideal for crumpets and muffins.
Toasting Tips
- Toasting is a combination of drying and cooking the bread, and because moisture levels differ from one bread to another, toasting times can vary.
- If your bread jams in the toaster, switch the power off, remove the plug from the power outlet and ease the bread out of the toaster.
Bread types
- For slightly dry bread, use a lower setting than normal.
- For fresh bread or whole wheat bread, use a higher setting than normal.
- When toasting raisin or other fruit breads, remove any loose raisins or fruit from the surface of the bread before putting it into your toaster. This will help prevent fruit pieces from falling into your toaster or sticking to the guard wires in the toasting slot.
- Bread which has a very uneven surface will require a higher setting.
Crumpets and thicker bread
- Thicker cut pieces of bread (including crumpets) will take longer to toast—sometimes significantly longer. This is because more moisture must be evaporated from the bread before toasting can occur. Very thick pieces of bread may require two toasting cycles.
Muffins and Bagels
- Ensure muffins or bagels are cut into even halves and fit freely into the bread slot. Do not force them into the toaster
Single slice toasting
If toasting 1 slice it is recommended that you use a lower toaster setting to
achieve your required browning and to prevent burning.
WARNING: Never attempt to extract jammed toast, muffins, bagels or
crumpets with a knife or any other metal object, as contact with the live
element may cause electrocution.
Care and Cleaning
Always turn the power OFF and remove the plug from the power outlet after use and before cleaning your toaster.
To clean the exterior
Wipe exterior with a slightly dampened cloth and polish with a soft dry cloth.
CAUTION: To prevent damage to the appliance, do not use alkaline,
chemical or abrasive cleaners as these may scratch the surface.
Removable Crumb Tray
To remove the crumbs, simply pull tray out, empty and place it back in the
toaster.
Important: Clean the crumb tray regularly. Do not allow crumbs to accumulate, as they may cause a potential fire hazard.
To clean the toaster interior
Clean inside the toaster regularly. To do this, unplug the appliance, turn it
upside down over the sink and gently shake all the crumbs out.
12 Month Replacement Guarantee
Should you experience any difficulties with your product during the warranty period, please contact our customer service line for advice on 1300 881 861 in Australia, or 0800 786 232 in New Zealand.
Australia
www.sunbeam.com.au
1300 881 861
New Zealand
www.sunbeam.co.nz
0800 786 232
This Sunbeam product is covered by a 12 month replacement or repair warranty, which is in addition to your rights under the Australian Consumer Law lif your product was purchased in Australial or New Zealand Consumer Guarantees Act lif your product was purchased in New Zealand).
Upon receipt of your claim, Sunbeam will seek to resolve your difficulties or, if the product is defective, advise you on how to obtain a replacement or refund.
To assist us in managing warranty claims, we recommend you register your product as soon as practicable after purchase, on our Sunbeam website and uploading a copy of your original receipt. View the Support section of the Sunbeam website.
In order to make a claim under our warranty, you must have the original proof of purchase documentation for the product and present it when requested (if not already uploaded to our website).
Should your product develop any defect within 12 months of purchase because of faulty materials or workmanship, we will replace or repair it, at our discretion, free of charge. A product presented for repair may be replaced by a refurbished product of the same type rather than being repaired. Refurbished parts may be used to repair the product.
Our replacement or repair warranty only applies where a defect arises as a result of faulty material or workmanship during the warranty period. Your warranty does not cover misuse or negligent handling including damage caused by failing to use the product in accordance with this instruction booklet), accidental damage, or normal wear and tear.
Your warranty does not:
-
cover freight or any other costs incurred in making a claim, consumable items, accessories that by their nature and limited lifespan require periodic renewal (such as filters and seals] or any consequential loss or damage;
cover damage caused by:- power surges, power dips, voltage supply problems, or use of the product on incorrect voltage;
- servicing or modification of the product other than by Sunbeam or an authorized Sunbeam service center;
- use of the product with other accessories, attachments, product supplies, parts or devices that do not conform to Sunbeam specifications; or
- exposure of the product to abnormally corrosive conditions; or
-
extend beyond 3 months if the product is used in commercial, industrial, educational or rental applications.
The benefits given to you by our warranty are in addition to other rights and remedies under law in relation to the product.
In Australia our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
Our goods also come with guarantees that cannot be excluded under the New Zealand Consumer Guarantees Act.
If your warranty claim is not accepted, we will inform you and if requested to do so by you, repair the product provided you pay the usual charges for such repair. You will also be responsible for all freight and other costs.
Should your product require repair or service after the warranty period, contact your nearest Sunbeam service center. For a complete list of Sunbeam’s service centers, visit our website or call our customer service line for advice on 1300 881 861 in Australia, or 0800 786 232 in No 7ooland
Need help with your appliance?
Contact our customer service team or visit our website for information and
tips on getting the most from your appliance.
-
Australia |
visit www.sunbeam.com.au
phone 1300 881 861 -
New Zealand |
visit www.sunbeam.co.nz
phone 0800 786 232
Newell Australia Pty Ltd. ABN 68 075 071 233
Sunbeam is a registered trade mark.
Made in China to Sunbeam’s specification.
Due to minor changes in design or otherwise,
the product you buy may differ slightly from the one shown here.
Approved by the appropriate electrical regulatory authorities.
©Copyright Sunbeam 2022.
06/22
TAP0002WH_TAP0003WH_22EM1 (ANZ)_GCDS-JC
PN: 4249A / 4250A / NWL0001438465
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>