bright starts 13031-MEES Wild Vibes Infant to Toddler Rocker User Manual

June 9, 2024
bright starts

bright starts 13031-MEES Wild Vibes Infant to Toddler Rocker

bright starts 13031-MEES Wild Vibes Infant to Toddler Rocker

IMPORTANT! KEEP FOR FUTURE REFERENCE

WARNING

FALL HAZARD: Children have suffered head injuries falling from rockers.

  • NEVER leave the child unattended.

  • ALWAYS use the restraint system. Adjust to fit snugly.

  • For children who can climb in and out of the rocker unassisted, the restraint system is not required.

  • DO NOT move or lift this product with the baby inside it. Never lift product using a
    toy bar as a handle.

  • NEVER place a child over 40 lb (18 kg) in the product.

  • The reclined position is only for children who cannot sit upright unassisted (until 20 lb or 9 kg).

  • The upright position is only for children who have developed enough upper body
    control to sit up without tipping forward.

  • NEVER use this product on an elevated surface (e.g. a table). ALWAYS use on the floor.

  • DO NOT place this product near a window as it can be used as step by the child and cause the child to fall out of the window.

  • Be aware of the risk of open fires and other sources of strong heat in the vicinity of
    the product.

  • DO NOT place this product near a window where cords from blinds or curtains could strangle a child.
    SUFFOCATION HAZARD: Babies have suffocated when seats tipped over on soft surfaces.

  • NEVER use on a bed, sofa, cushion, or other soft surface.

  • Stay near and watch baby during use. This product is not safe for sleep or unsupervised use. If baby falls asleep, remove baby as soon as possible and place baby on a firm, flat sleep surface such as a crib or bassinet.

  • Never let the child sleep in this product.

  • NEVER attach any additional strings or straps to product or toy bar.

  • NEVER use as an infant carrier or for automobile or airline travel.

CAUTION

  • This product contains small parts. Adult assembly required.

IMPORTANT

  • Please read all instructions before assembly and use of the product.
    • Care should be taken in unpacking and assembly.
    • Examine product frequently for damaged, missing, or loose parts.
    • DO NOT use if any parts are missing, damaged, or broken.
    • Contact Kids2 for replacement parts and instructions if needed. Never substitute parts.
    • This product does not replace a cot or a crib. Should the child fall asleep, then it
    should be placed in a suitable cot or crib.

Care and Cleaning

Seat pad – Remove from frame. Fasten buckles on seat restraint and seat pad. Fasten all hook-and-loop patches to the corresponding patch. Machine wash with cold water, gentle cycle. No bleach. Tumble dry, using low heat.
Toy bar and toys – Wipe clean with a damp cloth and mild soap. Air dry. Do not immerse in water.
Frame – Wipe the metal frame with soft, clean cloth and mild soap.

Battery Information

The vibration Unit requires (1) size C/LR14 (1.5V) alkaline batteries (not included).

CAUTION: Follow the battery guidelines in this section. Otherwise, battery life may be shortened or the batteries may leak or rupture. To prevent battery leaks, which can burn skin and eyes

  • Always keep batteries away from children.
  • Never mix old and new batteries, or batteries of different brands or types.
  • Always replace the entire set of batteries at one time.
  • Do not mix alkaline, standard, or rechargeable batteries.
  • Only batteries of the same or equivalent type as recommended are to be used.
  • Install the batteries so that the polarity of each one matches the markings in the battery compartment.
  • Do not short-circuit the batteries.
  • Do not store batteries in areas that have extreme temperatures (such as attics, garages, or automobiles).
  • Remove exhausted batteries from the battery compartment.
  • Never attempt to recharge a battery unless it is specifically marked “rechargeable.”
  • Rechargeable batteries are to be removed from the toy before being charged.
  • Rechargeable batteries are only to be charged under adult supervision.
  • Dispose of used batteries immediately.
  • Please use the correct disposal method for batteries.
  • Remove batteries before putting the product into storage for a prolonged period of time.
  • Weak batteries cause erratic product operation, including distorted sound, dimming or failed lights, and slow or non-working motorized parts. Because each electrical component requires a different operating voltage, replace the batteries when any function fails to operate.
  • Do not dispose of product or batteries in fire, batteries may explode or leak.

This symbol indicates that the product is not to be disposed of in household waste as batteries contain substances that can be damaging to the environment and health. Contact local authority for recycling & collection information.

No Qty. Description
A (2) M5 Phillips screws
B (2) M3 Phillips screws
1 (1) Seat frame side, left
2 (1) Seat frame side, right
3 (1) Rear cross bar
4 (1) Kickstand
5 (1) Backrest tube
6 (1) Footrest unit with vibration unit
7 (1) Seat Pad
8 (1) Toy bar with toys

Description

not included

Not Included

Assembly Instructions










Using the Seat Restraint

Using the Seat Restraint
Using the Seat Restraint

Using the Recline Function

Function Button

Disassemble the toybar

Disassemble the toybar

Find us on Facebook and Instagram @brightstarts

Toys • Activity Gyms • Bouncers • Rockers • Swings
Activity Centers • Walkers • Door Jumpers

brightstarts.com

MANUFACTURED FOR • FABRIQUÉ POUR ©2022 KIDS2, INC. www.kids2.com/help
KIDS2, INC. ATLANTA, GA USA 30305 • 1-800-230-8190

SymbolsKIDS2 US MÉXICO S.A. DE C.V. • (55) 5292-8488
MADE IN CHINA • HECHO EN CHINA • FABRIQUÉ EN CHINE • HERGESTELLT IN CHINA • WYPRODUKOWANO W CHINACH • PRODOTTO IN CINA

bright starts Logo

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

bright starts User Manuals

Related Manuals