Lights S09P1ET12A Wireless Remote Turn Signal Bike Tail Light User Manual
- June 9, 2024
- Lights
Table of Contents
WIRELESS REMOTE TURN SIGNAL
USER MANUAL
Function Description:
Remote control: a total of 3 buttons, each button is equipped with an indicator.
Product features:
- Large visual range.
- Easy to install.
- Built in 900mAh rechargeable battery, long life
- The surface waterproof effect reaches ipx2 to ensure daily use.
- High quality led to ensure the warning effect.
Operation method of tail lamp:
- When charging, please remove the tail lamp, open the protective cover of the rubber charging port on the back of the tail lamp, and plug in the micro plug for USB charging cable.
- The lamp and remote control are matched at the factory and can be used after installation.
- The tail lamp and controller are combined with the corresponding accessories, and then respectively installed in the appropriate position of the vehicle.
- When the battery is replaced after the match is forgotten because the battery is exhausted, long press the main light switch and remote control switch for 3 seconds at the same time.
Matters needing attention:
- Don’t disassemble and refit without permission.
- This product is only rain proof, do not soak the product in water.
- After use, please turn off the tail light switch button to avoid battery power loss.
- Pay attention to the battery inside the tail lamp, and do not replace it by yourself.
FCC Statement:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>