hyco Flow Through Valve Kit for Speedflow Installation Guide
- June 9, 2024
- hyco
Table of Contents
hyco Flow Through Valve Kit for Speedflow
Installation Instruction
Assemble the vessel, t – piece and flow through valve as shown in figure 1.
Screw the flow through valve as far into the t – piece as it will go and then
turn back if necessary to achieve the orientation shown.
PTFE tape or similar will be required to seal on the threads of both the
vessel and the flow through valve.
Orientation is important, the flow through valve water diverter paddle should
be at a 90° angle to the tube as shown in figure 2.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>