Pioneer CD-R55 Remote Control Owner’s Manual

: June 9, 2024
: Pioneer

Table of Contents

Before You Start
Before You Start
Setting remote control code type
Specifications
Button names and operation (Fig. 2)
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Pioneer CD-R55 Remote Control Owner’s Manual

Before You Start

If you want to dispose this product, do not mix it with general household waste. There is a separate collection system for used electronic products in accordance with legislation that requires proper treatment, recovery and recycling.

Private households in the 25 member states of the EU, in Switzerland and Norway may return their used electronic products free of charge to designated collection facilities or to a retailer (if you purchase a similar new one).

For countries not mentioned above, please contact your local authorities for the correct method of disposal.

By doing so you will ensure that your disposed product undergoes the necessary treatment, recovery and recycling and thus prevent potential negative effects on the environment and human health.

Information to User

Alteration or modifications carried out without appropriate authorization may invalidate the user’s right to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Use and care of the remote control

Installing the battery (Fig. 1)

Slide the tray out on the back of the remote control and insert the battery with the plus (+) and minus ( –) poles pointing in the proper direction .

When using for the first time, pull out the film protruding from the tray

WARNING

Handling the cord on this product or cords associated with accessories sold with the product may expose you to chemicals listed on
proposition 65 known to the State of California and other governmental entities to cause cancer and birth defects or other reproductive harm. Wash hands after handling.
Keep the battery out of the reach of children. Should the battery be swallowed, immediately consult a doctor

**CAUTION**

Do not allow this unit to come into contact with liquids. Electrical shock could result. Also, this unit damage, smoke, and overheat could result from contact with liquids.
Do not disassemble or modify this unit. To do so may cause a malfunction.
Always keep the volume low enough so that you can hear sounds from outside the vehicle.
Use only one CR2025 (3 V) lithium battery. ! Always check carefully that you are loading the battery with its plus (+) and minus ( –) poles facing in the proper directions.
Remove the battery if the remote control is not used for a month or longer.
Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
Do not handle the battery with metallic tools. ! Do not store the battery with metallic materials. ! In the event of battery leakage, wipe the remote control completely clean and install a new battery.
When disposing of used batteries, please comply with governmental regulations or environmental public institutions’ rules that apply in your country/area.
“Perchlorate Materialspecial handling may apply. Se www.dtsc.ca.gov/hazardouswaste/perchlorate. (Applicable to California, U.S.A.)

Using the remote control

Point the remote control in the direction of the front panel to operate.

Before You Start

The remote control may not function properly in direct sunlight.

Important

Do not store the remote control in high temperatures or direct sunlight.
Do not let the remote control fall onto the floor, where it may become jammed under the brake or accelerator pedal ****.

Using the remote control operation mode switch

There are three remote control operation modes on the remote control.

AVH mode operation
When operating an AV Receiver (e.g., AVHP5900DVD) with this remote control, the mode is normally switched to AVH

DVD mode operation
When operating a Pioneer DVD player (e.g., XDV-P6) with this remote control, the mode is switched to DVD. If you switch the mode to DVD, the joystick and 0 to 10 operations are changed for DVD player.

TV mode operation
When operating a Pioneer TV tuner (e.g., GEXP5700TV (P)) with this remote control, the mode is switched to TV. If you switch the mode to TV, the joystick operation is changed for TV tuner. In TV mode, only buttons shown below can be used.

SOURCE button
ATT button
VOLUME buttons
\Joystick
DIRECT button
REAR SOURCE button

Setting remote control code type

When the remote control operation mode switch is set to DVD, changing the remote control code type enables you to operate the Pioneer DVD player with this remote control. There are three remote codes, code type A, code type B and code type AVH.

code type A, code type B and code type AVH.
When operating an AV Receiver (e.g., AVHP5900DVD), select code AVH. ! When operating a multi-DVD player (e.g., XDV-P6), select code A.
When operating a DVD navigation unit, select code B

Set the remote control selection switch on the left side of the remote control to the appropriate position with a pen tip or other pointed instrument .
- If you select AVH mode, there is no need to take the following procedure.
- If you select A/ B mode, take the following procedure and change the code type to the appropriate type.
Press 0 and CLEAR on the remote control simultaneously to change the code type. Initially, the code type is set to A. Each time you press 0 and CLEAR simultaneously on the remote control the code type switches between A and B.

Specifications

ower source ……………………….. 3 V DC (Lithium battery;
CR2025)
Dimensions (W × H × D) … 54 × 149 × 13 mm
(2-1/8 × 5-7/8 × 1/2 in.)
Weight …………………………………… 59 g (2 oz) (including battery

Infrared remote control

Wavelength ………………. 945 nm
Output ………………. typ; 10 mw/sr per Infrared LED

Note
Specifications and the design are subject to possible modifications without notice due to improvements.

Button names and operation (Fig. 2)

	Button names	AVH mode	DVD mode
1	Remote control selection switch	Switch to change the setting of the remote

control. For details, refer to Setting remote control code type.
2| SOURCE button| Press to cycle through all the available sources. Press and hold to turn the source off
3| ATT button| Press to quickly lower the volume level, by about 90%. Press once more to return to the original volume level.
4| VOLUME buttons| Press to increase or decrease the volume.
5| AUDIO button| Press to change the audio language during DVD playback
SUBTITLE button| Press to change the subtitle language during DVD playback
ANGLE button| Press to change the viewing angle during DVD playback.
7| buttons (DISC)| Not used.| Remote control code: AVH or B Not used. Remote control code: A Press to select the next/previous disc.
8| Remote control operation mode switch| Switch the operation mode between AVH, DVD and TV modes. Normally, set to AVH. For details, refer to Using the remote control operation mode switch.
9| BOOKMARK button/ PGM button| Press to operate the preprogrammed functions for each source. For details, refer to AV Receiver’s operation manual.| Press to operate the preprogrammed functions for each source. For details, refer to AV Receiver’s operation manual.
10| DIRECT button| In U.S. and Canada: Press to do direct XM/SIRIUS channel select. In other area: Not used.| Not used.
11| REAR SOURCE button| Not used.| Remote control code: AVH Not used. Remote control code: A or B Press to turn the DVD player on or off.
12| DISPLAY button| Press to select different displays.| Remote control code: AVH Not used. Remote control code: A or B Press to select different displays.
13| ENTERTAINMENT button| Not used.
14| 0 to 10 buttons, CLEAR button| Press 0 to 10 to input numbers. Buttons 1 to 6 can operate the preset tuning for the tuner or disc changing for DVD player or multi-CD player. Press CLEAR to clear the input numbers.| Press to select a menu item on the Video CDs featuring PBC (playback control).
15| BACK button| Press to return to the previous display| Not used.
16| BAND button| Press to select the tuner band when tuner is selected as a source. Also used to cancel the control mode of functions. Press to switch mode between compressed audio and audio data (CD-DA) when playing discs with compressed audio and audio data (CD-DA) such as CD-EXTRA and MIXED-MODE CDs.| Press to switch mode between compressed audio and audio data (CD-DA) when playing discs with compressed audio and audio data (CD-DA) such as CD-EXTRA and MIXED-MODE CDs.
17| PLAY/PAUSE button| Press to switch sequentially between playback and pause.
REVERSE button| Press to perform fast reverse.
FORWARD button| Press to perform fast forward.
PREVIOUS button| Press to return to the previous track (chapter).
NEXT button| Press to go to the next track (chapter)
STEP Button buttons| Press to move ahead one frame at a time during DVD/VideoCD playback. Press and hold for one second to activate slow playback.
STOP button| Press to stop playback.
18| AUTO PLAY button| Press to turn the DVD auto-playback function on or off.
19| buttons (FOLDER)| Press to select the next/previous folder
2O| Joystick| Move to do fast forward, reverse and track search controls. Click to recall MENU.| Move to select a menu on the DVD menu.
21| MENU button| Press to display the DVD menu during DVD playback.
TOP MENU (TOP.M) button| Press to return to the top menu during DVD playback.