EVENT LIGHTING VIVIDSTARTER LED Party Bar Light User Manual

June 9, 2024
EVENT LIGHTING

EVENT LIGHTING VIVIDSTARTER LED Party Bar Light

EVENT-LIGHTING-VIVIDSTARTER-LED-Party-Bar-Light-PRODACT-
IMG

For safety, please read this user manual carefully before initial use.
Event Lighting reserves the right to revise the manual at any time. Information and specifications within this manual are subject to change without notice. Event Lighting assumes no liability or responsibility for any errors or omissions. Please consult Event Lighting for any clarification or information regarding this item.

Safety Instructions

Warning

  • Do not open this fixture, there is no user-serviceable parts inside. Risk of electric shock.
  • Do not look directly at the light source when the fixture is on.

Caution: This unit’s housing may become hot during and after operation.

  • Install this fixture in a location with adequate ventilation, at least 50 cm from adjacent surfaces.
  • Do not leave any flammable material within 50 cm of this unit while operating or connected to power.
  • Use a safety chain when mounting this fixture overhead.
  • Do not operate this device in any location where excessive dust, heat, water or humidity may affect it.
  • Do not operate this fixture if the housing, lenses, or cables appear damaged.
  • Do not connect this fixture to a dimmer or rheostat.
  • ONLY connect this fixture to a grounded and protected circuit.
  • ONLY use the hanging bracket to carry this fixture.
  • In case of a serious operating problem, stop using immediately.
  • The maximum ambient temperature is 40° C. Do not operate this fixture at higher temperatures.

Power Input

  • This fixture has an auto switching power supply that works with an input voltage range of 110- 240V AC, 50/60 Hz.

IR Remote

EVENT-LIGHTING-VIVIDSTARTER-LED-Party-Bar-Light-FIG-1

Technical Specifications

  • PAR: 7x 2W RGB LED
  • LED Ball: 3x 3W RGB LED
  • Strobe: 3x 4W UV/Whtie LED
  • Red Laser: 100mW
  • Green Laser: 30mW
  • Operation Modes: Auto, sound active, IR remote (included)
  • Stand included
  • Input Voltage: 110-240V AC, 50/60 Hz
  • Power Consumption: 40 W

Warranty

Please contact your local dealer or contact Event Lighting.  www.event- lighting.com.au

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

EVENT LIGHTING User Manuals

Related Manuals