LANCOM GS-3628XUP Fully Managed Access Switches User Guide
- June 9, 2024
- LANCOM
Table of Contents
LANCOM GS-3628XUP Fully Managed Access Switches
Hardware Quick Reference LANCOM GS-3628XUP
-
Configuration interface (Console)
Connect the configuration interface via the included serial configuration cable to the serial interface of the device you want to use for configuring / monitoring the switch. -
TP Ethernet interfaces 10M / 100M / 1G PoE+
Use Ethernet cables to connect the interfaces 1 to 12 to your PC or a LAN switch. -
TP Ethernet interfaces 100M / 1G / 2.5G PoE++
Use Ethernet cables to connect the interfaces 13 to 24 to your PC or a LAN switch. -
SFP+ interfaces 1G / 10G
Insert suitable LANCOM SFP modules into the
SFP+ interfaces 25 to 28. Choose cables which are compatible with the SFP modules and connect them as described in the module’s documen tation. -
Power connector (device back side)
Supply power to the device via the power connector. Please use the IEC power cable supplied or a country-specific LANCOM Power Cord.
ATTENTION: High touch current possible! Connect to earth before connecting the power supply.
Before initial startup, please make sure to take notice of the information regarding the intended use in the enclosed installation guide! Operate the device only with a professionally installed power supply at a nearby power socket that is freely accessible at all times.
INFORMATION
Please observe the following when setting up the device
- → The power plug of the device must be freely accessible.
- → For devices to be operated on the desktop, please attach the adhesive rubber footpads
- → Do not rest any objects on top of the device
- → Keep all ventilation slots on the side of the device clear of obstruction
- → Mount the device into a 19” unit in a server cabinet using the provided screws and mounting brackets.
- →Please note that support service for third-party accessories is excluded.
This product contains separate open-source software components which are
subject to their own licenses, in particular the General Public License (GPL).
The license information for the device firmware (LCOS) is available on the
device‘s WEBconfig interface under “Extras > License information“. If the
respective license demands, the source files for the corresponding software
components will be made available on a down-load server upon request.
Hereby, LANCOM Systems GmbH | Adenauerstrasse 20/B2 | D-52146 Wuerselen,
declares that this device is in
compliance with Directives 2014/30/EU, 2014/35/EU, 2011/65/EU, and Regulation
(EC) No. 1907/2006. The full text of the EU Declaration of Conformity is
available at the following Internet address: www.lancom-
systems.com/doc
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>