etac Hi-Loo Med Kantstopp with Brackets User Manual
- June 9, 2024
- Etac
Table of Contents
etac Hi-Loo Med Kantstopp with Brackets
Thank you for choosing an Etac product. In order to avoid damage during assembly, handling and use, it is important to read this manual and save it for future reference. You can also find it at www.etac.com. You can select your language via the “International” and “Local websites” link. Here you will also find other product documentation, such as prescriber information, pre purchase guide, and reconditioning instructions.
General
The Etac Hi-Loo with brackets is a toilet seat raiser designed for use on the
toilet bowl. It has been developed to facilitate toilet use by persons who
have restricted mobility and who need a raised toilet seat.
The product conforms to the requirements of the Medical Devices Regulation
(EU) 2017/745. Contra indications
There are no known contraindications.
Installation and use
- Undo the four fixing screws. The screws should be loosened only. Do not remove completely!
- Move the four brackets towards the outside of the seat. Tighten the screws so that it still will be possible to turn the brackets one more click.
- Place the Hi-Loo on the toilet bowl and adjust it until there is contact at the front of the bowl.
- Turn the rear and front brackets at the side towards the bowl.
- Slowly lift the Hi-Loo away from the bowl. Turn all four brackets one click inwards. Now tighten the screws. Important: The brackets must remain in position!
- Attach the Hi-Loo to the bowl, front brackets first. Then use downward pressure to secure the rest of the Hi-Loo to the bowl. Check it is securely attached.
Maintenance and safety
- Clean/disinfect the chair with normal non-abrasive cleaning agents with a pH value of between 5-9, or with 70% disinfectant solution. Rinse and dry. The product is otherwise maintenance-free.
- The product can withstand cleaning in a sterilizer at 85°C for 3 minutes. This applies for reconditioning.
- Maximum user weight (see technical data).
- A defective product must not be used.
- Heated chair can cause burns.
The materials used are corrosion-resistant.
The materials used are resistant to all general disinfectants.
In case of an adverse event occurred in relation to use of the device, it should be reported to your local dealer and the national competent authority in a timely manner. The local dealer will forward informa-tion to the manufacturer.
Guarantee, service life
5-year guarantee against material and manufactur-ing defects. For terms and
conditions, see
www.etac.com.
Service life 10 years. For complete information regarding the service life of
the product, see
www.etac.com.
The product’s date of manufacture can be read from the barcode on the product.
The number 11 is shown below the barcode in brackets. The number combination
after these brackets is the date of manufacture.
Storage
The product should be stored indoors in a dry place at a temperature above
5°C. If the product has been stored for a long time (more than four months),
its function must be checked by an expert before use.
Technical data
| 6 cm | 360 mm | 390 mm | 200 mm | 270 mm | 1.1 kg | 150 kg |
|---|---|---|---|---|---|---|
| 10 cm | 360 mm | 390 mm | 200 mm | 270 mm | 1.5 kg | 150 kg |
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>