arteconfort Luxor LED Solar Outdoor Wall Light Instruction Manual

arteconfort Luxor LED Solar Outdoor Wall Light

THANKS FOR TRUSTING IN ARTECONFORT

Congratulations, you have just purchased an Arteconfort solar lamp: cutting edge technology combined with the highest energy efficiency.

CAUTION

• Use and unauthorized technical modifications could suppose a risk of injury.
• This device can be used by children aged 8 years and above and of people with reduced physical, sensory or mental abilities or lack of experience and knowledge if they are supervised or instructed about the use of the device safely and understand the risks involved. As well as cleaning and maintenance of the device.
• Children should not play with the device.
• The instructions and safety regulations in this manual cannot prevent all conditions and situations that may occur. For obvious reasons, this manual cannot include factors such as caution and care. These factors must be assumed by who installs, maintains, uses and enjoys the product.

WARNING
Read this instruction manua carefully before beginning installation and save it tor tuture reference. In case ot transter ot the device, you must also give this instruction manual to the corresponding person.

GUARANTEE

• You can check the warranty for this product on its corresponding page at the end of this manual.

BEFORE INSTALLATION
Open the box and unpack the pieces, handling them carefully so they do not get damaged. It is advisable to have a sufficiently large surface to perform the installation. Identify all parts before beginning assembly.

LIGHT MODES

1. .During the daytime, the system is charging, and the light is turned ott. At night, the system starts lighting automatically
2.  When installed, allow the battery to charge for 1 or 2 days betore the tirst use
3. Press the buttom to start the tirst mode, then each press ot a buttom will replace a light mode:
4. Always light mode: it will always light at night, no induction tunction.
5. Body sensor +micro-mode: when someone comes, the light will be strong. When no one comes, the light will be bright slightly.
6. Human body induction mode: when some one comes, the light will be strong. When no one comes, the light will turn off.
7. Flashing emergency light mode. Shutdown: the battery will keep charging but the light will not turn on.
8. It will work according to the installed mode every day, no need to swith again.
   The delay time tor sensor is 15 seconds.

MAINTENANCE

• If the luminaire does not turn on at night because the battery has been discharged, turn it oft and allow it to charge for 1 or 2 days before turning it on again.
• Clean the appliance regularly to maintain its appearance as new. To do this, use a soft, lint-free cloth to avoid scratching the finish.
• Be sure to install the product in an area where it receives direct sunlight for optimal charging
• Select an outdoor location away frorn other night source at night, such as street lights. Other lights may cause the product to not turn on automatically at night.
• The replacement of the battery must be done by a licensed electrician. battery

ENVIRONMENT

• Do not throw electrical appliances into the household waste, use selective collection facilities. Consult local authorities for more intormation.
• It electrical appliances are deposited in landtills, hazardous components can seep into groundwater and enter the food chain, damaging health and well- being.
• Thanks for taking care of the environment.

“NOTE: DO NOT INSTALL IN SHADED AREAS

WARRANTY

This solar light is guaranteed for 3 years. This warranty covers the exchange or repair of any failure or defect of the device, provided that it is due to a manufacturing fault or a defective component.

IMPORTANT
It is essential for the use of this guarantee to prove the purchase date of the product. Therefore, it will be necessary to present the purchase receipt as well as this instruction manual.

Keep the purchase receipt and the  instruction manual.

The warranty of this product does not apply if the defects of the device have been caused by:

• Damage during transport not carried out by the manutacturer. (Example: dents, glass pieces damages.)
• Carrying out incorrect installations or assemblies. Poor preservation of the product.
• Damage caused by contact of the device with chemical or inappropriate substances. The components or
• The replacement or use ot additional parts accessories that are not original from the or manutacturer.

If you have any questions, problems or missing components, consult your dealer. You can also contact us through the email info@arteconfort.com or through the contact form available on our website.

www.arteconfort.com ARTECONFORT HOTEL S.L. Ctra. Andaluda, 6 45224 Sesefia Nuevo Toledo, Espana

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>