ABH 2300 C28 Surface Mount Magnetic Door Holder Instruction Manual

ABH 2300 C28 Surface Mount Magnetic Door Holder

WALL PORTION INSTALLATION:

• Measure distance from pivot centerline to wall (Dim. “A”).

• Determine door width (Dim. “B”).

• Use table below to locate magnet box on wall (Dim. “C”).

• Example : Dim. “A” = 10″ Dim. “B” = 42″ Result Dim. “C” = 38-7/8″.

• If Dim. “A” or Dim. “B” falls between dimensions listed in the table below, allow for difference.

• Example : Dim. “A”= 7” Dim. “B” = 36″ Then Dim.”C” = 33-1/8″.

• If Dim. “A” and Dim. “B” intersect in the shaded area, DO NOT INSTALL magnet box.

• The degree of door opening will not allow for proper alignment between armature and wall magnet.

• Suggested vertical location is on top rail approximately 5″ from top of the door.

• Check degree of door opening shown in table and coordinate with door closer and other door hardware.

• Total projection of door hardware must not be more than 3-5/8″ on the pull side of door.

• If greater, you will need to use additional extensions, sold separately.

• From corner of wall, measure the appropriate Dim. “C” determined in step 3.

• Proper electrical wire routing must be done before installing magnet box.

• The 4″ x 2-1/8″ x 2″ outlet box (not provided with unit) should be installed with reinforcement to withstand a minimum 50 lb. pull.

DOOR ARMATURE ASSEMBLY

2100 MAGNETIC WALL PORTION

VIEW

TOP VIEW
FRONT  VIEW

ELECTRICAL DATA

DOOR ARMATURE INSTALLATION

• Place and center the door armature on the surface of the magnet with the two holes of the base aligned horizontally.
• Gently close the door and adjust the angle of the door armature so the base lays flat against the door.
• While keeping slight pressure on the door, mark location of door armature through the two base holes.
• Drill through the door where the two marks are located with 5/16″ drill.
• Fasten with the (2)10-32 machine screws & sex bolts provided.

HELP

• www.abhmfg.com
• E-mail: abhinfo@abhmfg.com
• Architectural Builders Hardware Mfg., Inc.
• 1222 Ardmore Ave., Itasca, IL 60143
• 630.875.9900; FAX 800.9FAXABH (932.9224)

References

• Architectural Builders Hardware Mfg. Inc.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>