AMEWi 22534 G485E 1:14 Electric RC scale Instructions

22534 G485E 1:14 Electric RC scale
Instructions

**FUNCTION INTRODUCTION OF REMOTE CONTROL

**

Installation of Remote Control Battery

1. Loosen the screw of battery cover by screwdriver and take out battery cover. (Pic .1)
2. Put four 1.5V. non-rechargeable batteries (batteries need to be purchased separately) into the battery box to the right polarity at the bottom of remote control. (Pic .2)
3. Install the battery cover and tighten the screw. (Pic .3)

Battery Installation Instructions

1. Take out and install battery correctly.
2. The non-rechargeable battery can’t be charged.
3. The rechargeable battery can only be charged under custody of adults;
4. Different batteries or new and old batteries can’t be used together;
5. Battery of same model or recommended model can be us.;
6. The rechargeable battery should be taken out from model before changing.
7. Battery should be placed with correct polarity;
8. The exhausted battery should be taken out from model;
9. Short-circuit of battery terminal is forbidden;

INSTALLATION OF LOADER BATTERY

1. Loosen screw of battery cover by screwdriver, twist the locker and take out battery cover. Battery cover buckle

2. Connect lithium batteries with power pot of loader, then put in the battery box.

3. Install the battery cover, Ught the screw and twist the locker, battery installation completed.

Battery Charging Instructions

CHARGING METHODS
Connect the white port of Li-Po to USB charging port, as shown in the Figure, and ensure port can be connected tightly and correctly, then insert the USB charging plug into power adapter, and perform charging.
BATTERY/USB PARAMETERS
Battery specifications: 18650 7.4V 2000mAh Li-Po
Intelligent USB balance charger with overcharge protection Input: 5.0V 1-2A Output:4.2V 800mAh X2
INDICATOR LIGHT STATUS AT THE TIME OF CHARGING:
Uncharged state: red light always lit Charged state: Red light always lit + Green light flashes Full charging state: Red and green light always lit Charging period: 34 hours When battery is charged, please pull off the USB charger lead in time.
Precautions Of Li-Po

1. Battery can be charged only by originally configured USB charger lead;
2. Be sure to charge with white big-socket port while not the black socket;
3. 7.4V Li-Po must be equipped with 5V USB charging plug;
4. The Li-Po with damaged appearance can’t be charged, to avoid fire hazards resulted from spontaneous combustion.
5. Li-Po must be charged in sheet iron box; 6. Battery should be charged within specified charging period.

Safe Usage Instructions for Li-Po

• Li-Po is of higher danger compared with other batteries. Be sure to carefully read the instructions and follow precautions and charging methods before usage.
• This company won’t bear any responsibility resulted from improper usage.
• It is strictly forbidden to charge Li-Po with non-original charger, to avoid explosion and fire hazards. Impact, dismantling, inverse connection of positive and negative polarities and incineratingbattery are strictly forbidden, to avoid short circuit resulted from metal objects’ impacting positive and negative polarities of battery. And please prevent sharp objects from penetrating battery, to avoid catching fire of battery.
• Be ,dent and careful to perform charging, to ensure charging can be perforrned within your visibility range.
• Charger should be out of reach of children to avoid danger.
• The degraded battery shouldn’t be charged, otherwise, battery expansion, deformation, explosion even fee hazard will occur, endangering safety and Sues end properties.
• The discarded batteries should be recovered by strictly following national or regional waste disposal decrees, so as not to pollute environment.

A, WARNING
•This product is composed of small parts, don’t let children of 14 years or below play it.
•The motor can generate he.; don’t touch it to avoid scald.
•The wire, plug, shell and other parts of battery charger should be periodically checked, in case of any damage, don’t use it till repaired well.
Maximum Transmitting Power
Operation frequency: 2.405 – 2.475 MHz
Maximum Radio frequency power: maximum peak power: OdBm
REMOTE CONTROL FREQUENCY PAIRING AND POWER ON
This product is equipped with remote control of 2.4GHz. When a user operate it for the first time, please install batteries into model and remote control, then turn the power on, the model is turned on and frequency is automatically pair., and frequency pairing sound is given, ‘beeps° indicates the frequency has been paired.
LIGHT & SOUND CONTROL
Press the sound switch to open the sound effect, and press again to close (circulating)
Press the light switch to turn on the light, and press again to turn off (circulating)
Arm Balance Tweaks
When the bucket is found inclining I. or nght, adjust the balance by tweaks hu

Push up I. tweaks button, Men laftannrno.s up,| Push up right tw.ks button, Men nob( arm rn.es up,

Pull .wn lsfl tweaks butt.. then lab arm moves down:| Pull .wn right… button. then right arm moves down:

Operating Instruction of Loader

Declaration of Conformity
This product has been manufactured according to actual technical standards. The product is matching the requirements of the existing european and national guidelines. The Declaration of Conformity has been proofed. AMEWI TRADE GrnbH declares that thi! product is rnatching the basic requirements and remaining regulations of the guideline 2014/53/EU (RED). The declarations and documents are stored at the manufacturer and can be requested and applied there.
The full text of the declaration of conformity can be found at: https://amewi.com/Konformitaetserklaerungen
For additional questions to the product and conformiry please contact: AMEWI TRADE GmbH Nikolaus-Otto-Str. 18, 33178 Borchen or via the website amewi.com
Security and Hazard Warnings
Waming For damage, caused by disregarding of the manual, warranty expires We are not liable for secondary failures, material or personal damage, caused by inproper usage or disregarding the security notices.
Warning! Based on security and registration (CE) reasons, it is forbidden to rnodify the product personally. Do not disassemble the product.
Waming Small parts. Danger of suffocation or risk of injury caused by small parts.
The product is not allowed to get moist or wet. The product is only allowed to be used on flat and clean surfaces. Even a drop down frorn a small height can cause damage to the product.
Battery Notice and Battery Disposal
Waming  Battery do not belong in childrens hands. A change of the battery has to be done by an adult person. Never mix chargable batteries with non- chargable batteries. Never mix fully charged batteries with almost emtpy batteries. Never mix batteries of different capacities. Never try to charge dry batteries. Take care of the correct polariry. Defective batteries belong to special waste. Never leave a charging battery unattended. For questions about the charging time please read the rnanual or ask the manufacturer.
Disposal
The company AMEWI is registered below the WEEE Reg. Nr. DE93834722 at the foundation EAR and recycles all used electronic parts properly. Electric and electronical products are not allowed to put in household garbage. Please dispose the product at the end of the lifetime accroding to the actual laws. You as a customer are responsible by law for the return of all used batteries, a disposal over the household garbage is forbidden .
**** Batteries containing hazardous substances are marked with the alongside symbols, which point to the prohibition of disposal in household garbage.
Additional notations for the critical heavy metal are: Cd=Cadmium, Hg=Quecksilver, Pb=lead (Label is placed on the batteries, for example below the bottom left trash symbols).
Additional notations for the critical heavy metal are: Cd=Cadmium, Hg=Quecksilver, Pb=lead (Label is placed on the batteries, for example below the bottom left trash symbols).
Based on RoHS labeling the manufacturer confirmes, that all limit values were taken care of at the time of manufacturing.
Batteries labeled with the recycling symbol can be put into used battery collecting tank. (Most supermarkets have) They are not allowed to be put into local household garbage.
AMEWI is involved in the dual system for boxing over the company Firma Landbell AG. All used boxes are collected from partner companies (waste disposal contractor) at private customers (local household), sorted and properly utilized. The Involvement in a Dual Systems helps to save CO2 Ernissions.

AMEWI Trade GmbH
Nikolaus-Otto-Str. 18
33178 Borchen
Germany
amewi.com
service@amewi.com

References

• The domain name EEWI.COM.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>