VARDAFLEX 86478 IP67 5 Meter LED Strip Light Instructions

June 9, 2024
VARDAFLEX

VARDAFLEX 86478 IP67 5 Meter LED Strip Light Instructions
VARDAFLEX 86478 IP67 5 Meter LED Strip Light

Risk of electric shock!
Be sure to have a professional electrician complete installation. There is no warranty coverage for any lights installed without observing European safety directives.

Caution!
Only connect the LED board to a suitable power supply (24 V DC). Only operate when completely unrolled. Connect LED boards in parallel.

DELIVERY INCLUDES:

  • 01 x 5 metre LED strip
  • 01 x power supply connector
  • 01 x end cap
  • 10 x fixing brackets

TECHNICAL DATA:

Power supply 24 V power supply with constant output voltage
Power 24 W
Current strength 1 A
Radiation angle 120°
Quantity LED 300
Length Maximum 10 metres per connection
Dimensions 5000 x 8 x 3 mm
Bending diameter 70 mm

 Compliant with the applicable european CE directives

 RoHS mark for products that do not contain heavy metals (EC Directive 2002/95/EC)

 REACH test mark for products whose chemical components are known, registered and authorised

 Safety class 3 – low voltage protection

 parallel circuit

Suitable for indoor Suitable for indoor use only

INSTALLATION

Risk of electric shock!
Switch off voltage prior to installation. Ensure that voltage cannot be accidentally switched on again.

Caution!
On conducting surfaces, place an insulation layer between the LED strip and surface. Surfaces must be flat, free of dust, grease and dry.

  1. Prepare surface.
  2. Shorten LED strip if necessary.
  3. Peel off adhesive film and gently press on LED strip, do not press directly on the LEDs.
  4. Connect LED strip to power supply

SHORTENING THE LED STRIP:

Risk of electric shock!
Always disconnect the mains plug before shortening. LED strip can be separated in each case after eight LEDs (125 mm) (fig. 1).

EIGHT LEDS VIEW

Separate the LED strip at the marked position. For a tightly assembled LED strip is a micro side cutter or an optional cutter required.

Glue the end cap with neutral cross-linking silicone at the end of the separation point.

Caution!
With soldered connections note that the soldering temperature is 260° C and the soldering duration a maximum of 10 seconds per soldering point. Only use neutral cross-linked silicon (never use silicon which includes vinegar!).

CONNECTION

  1. Fix a two-wired stranded connection cable with the help of lead-free solder to the soldering contacts of the separation point in compliance with the above-mentioned soldering temperature indication.
  2. Close open silicone tube ends with neutral cross-linking silicone.

 DISPOSAL

Dispose of electrical and electronic equipment in an environmentally friendly manner. Please contact your local council for further information.

RUTEC ICON

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals