Akuvox R20K RF Card Reader User Guide
- June 9, 2024
- Akuvox
Table of Contents
Akuvox R20K RF Card Reader
Unpacking
Before you begin using the device, please check the version you got and ensure that the following items are included in the shipped box:
Universal Accessories:
Wall-mounting Accessories:
Product Overview
Installation Environment
Indoor and outdoor installation are supported. If installing the device
outdoors, please don’t place device under direct sunlight, ii will bring a bad
effect or be broken with the high temperature. If installing the device
indoors, please keep device at least 2 meters away from light, and at least 3
meters away from window and door.
Wall-mounting Installation
Step l: Wall-mounting Bracket Installation
- With embedded one-gang junction box(86×86 mm or 2×3 inches in size) in the wall.
- Without embedded junction box in the wall.
Step 2: Back Cover Installation
Device Wiring
Application Network Topology
IP Announcement
- While R20K starts up normally, press 3258, voice system will enter IP announcement mode.
- In announcement mode, the IP address will be announced periodically.
- Press Cancel Button again to quit the announcement mode.
- In announcement mode, phone announces “IP 0.0.0.0” if no IP address is gained.
Configuration
- Access the Web UI: Input the IP address into web browser to configure the phone.
- Account Registration: On web UI, go to the path: Account-> Basic page Register Account and fill in the account information. ( Please refer to user manual for more information)
- Configure the Push Button: On web UI, go to the path: Intercom -> Basic-> Push Button to configure the call number.
- Configure the code to open the relay: On web UI, go to the path: Intercom-> Relay -> Relay IDIDTMF and choose the DTMF code number in the corresponding area.
Operation
-
Make a call:
- Press the SIP number or IP address and dial key to make a call.
-
Receive a call:
R20K supports Auto Answer by default. Incoming call will be answered automatically. -
Unlock:
1. During the talk, called party can press pre-configured code number to unlock the door;
2. Scan the predefined RFID card nearby the card reader to unlock;
3. Press the predefined pin code to unlock.Indicators
Notice Information
Akuvox R20K firmware contains third-party open-source software under the
terms of the GNU General Public License(GPL). Akuvox is committed to meeting
the requirements of the GNU General Public License (GPL) and will make all
required source code available.
The source code of software under the tenns of GNU GPL can be downloaded
online: http://www.akuvox.com/gpl.
Information contained in this document is believed to be accurate and reliable
at the lime of printing. This document is subject to change without notice,
any update to this document can be viewed on Akuvox’s website:
http://www.akuvox.com © Copyright 2020 Akuvox Lid. All rights reserved.
AKUVOX (XIAMEN) NETWORKS CO., LTD.
ADD: 10/F, NO.56 GUANRI ROAD, SOFTWARE PARK II, XIAMEN 361009, CHINA
www.akuvox.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>