Alecto BW-70 Bottle Warmer Instruction Manual

: June 9, 2024
: Alecto

Table of Contents

IMPORTANT SAFEGUARDS
IMPORTANT USER TIPS
IMPORTANT SAFEGUARDS
OPERATION
MAINTENANCE INSTRUCTIONS
TECHNICAL SPECIFICATIONS
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

BW-70 Bottle Warmer
Instruction Manual

IMPORTANT SAFEGUARDS

This appliance is intended to be used in household and similar applications. This appliance should not be used for direct commercial purposes or operated in moving vehicles. When using electrical appliances, basic safety precautions should always be followed including the following:

Read this safety information through carefully before using the appliance and keep it in a safe place.
This device may be used by children 3 years of age and older and by persons with reduced physical, sensory or mental capacity or lack of experience provided they are supervised or instructed in the safe use of the device and have understood the resulting hazards.
Children may not play with the device.
Children may not carry out cleaning and user maintenance tasks unless they are aged over 8 and are under supervision.
Children under the age of 3 should be kept away from the appliance and the power supply cable.
Do not use the baby food warmer in the event of obvious defects on the appliance, cable or connector.
If the mains cable is damaged, it should be replaced by the manufacturer, its Customer Service, department or a similarly qualified person in order to prevent hazards.
Mains voltage must match the voltage quoted on the underside of the appliance.
Do not warm baby food for too long. For food hygiene reasons, do not exceed one hour.
Bottles or jars may not be tightly sealed during heating in the baby food warmer, otherwise excessive pressure may build up (risk of explosion/ material damage).
Do not immerse the appliance in water or any other liquids.
Do not use it outdoors.
The appliance may not be operated with an external timer or a separate remote control system like a remote control socket, for example, because the appliance should never leave unsupervised during operation, so that you can intervene in good time if it malfunctions.
Only use the appliance for warming baby food in a domestic environment. Incorrect use involves potential hazards to the user.
Set up the baby food warmer so that it is steady and level and so that your child cannot tip it over or pull it off the table or kitchen counter by its cable.
The appliance should never be placed in the vicinity of hot surfaces,in heated ovens or in the vicinity of gas or electrical appliances, as this may cause damage to the appliance.
To protect you against an electric shock, the cable should not come into contact with water or cooker hotplates
After warming, stir the contents of the jar. Before feeding your child, check on the inside of your wrist whether the temperature of the food is safe for your baby. A sensible temperature is around 37 °C, which is the same as your own body temperature.
After use unplug the appliance from the mains to prevent it from being inadvertently switched on.

SAVE THE INSTRUCTIONS
Examples of Heating times:
Warming milk (30ml)
START (T=0): MILK = 13°C, KNOB SET TO POSITION :
T+2 MIN, MILK = 20°C
T+4 MIN, MILK = 26°C
T+6 MIN, MILK = 30°C
T+8 MIN, MILK = 32°C
T+10 MIN, MILK = 33°C
Warming food (125 CC)
START (T=0): FOOD = 16°C, KNOB SET TO POSITION :
T+3 MIN, FOOD = 21°C
T+5 MIN, FOOD = 25°C
T+10 MIN, FOOD = 34°C
T+12 MIN, FOOD = 40°C
T+14 MIN, FOOD = 45°C
T+15 MIN, FOOD = 50°C
Semi Sterilize (boiling method, With 100ml of Water)
START (T=0): WATER = 21°C, KNOB SET TO POSITION MAX:
T+3 MIN, WATER = 45°C
T+6 MIN, WATER = 68°C
T+9 MIN, WATER = 82°C
T+12 MIN, WATER = 87°C
T+15 MIN, WATER = 90°C
T+18 MIN, WATER = 90°C
DECLARATION OF CONFORMITY
The declaration of conformity is available on the website WWW.ALECTO.NL
ENVIRONMENT
At the end of the product lifecycle, you should not throw this product into the normal household garbage but bring the product to a collection point for the recycling of electrical and electronic equipments.

IMPORTANT USER TIPS

The final temperature of the milk or food is determined by the amount of water in the bottle warmer. If the temperature is too high, it is recommended to use less water in the bottle warmer. In case the temperature is too low, use more water.
It is advised to regularly take out the bottle or pot and shake or stir well for an even heating of the content.

IMPORTANT SAFEGUARDS

Read and save these instructions.
Never use the unit without water in it.
Do not move an appliance containing hot liquids.
Do not immerse appliance, cord or plugs in water or other liquid.
Place the Baby Bottle Warmer out of the reach of children and on a dry, nonslip, horizontal surface.
Close supervision is necessary when the unit is used near children.
Do not let cord hang over edge of table or counter.
Do not place on hot surfaces or in a heated oven.
Only use the Baby Bottle Warmer when the ambient temperature is between +7ºC and +37ºC.
Change the water in the bottle warmer each time after use for hygienic reasons.

OPERATION

Place the pot (without lid) or bottle in the container and fill the space between the bottle and the inner container with water up to half the bottle’s content.
Turn the control knob into position (35ºC for the warming of milk, 70ºC for the heating of food).
Plug the Baby Bottle Warmer into the mains socket.
The indication lamp lights, indicating that the water is being heat up. As soon as this lamp dims, the water has reached its temperature and from now on the lamp will go on and off on a regular base, indicating that the water is kept on the set temperature.
The time it needs to warm up the milk or the food depends on the quantity and on the temperature the milk or food has before heating up. (room temperature or coming from fridge).
Stir the contents of the bottle or pot frequently for more rapid distribution of heat.
After a few minutes the food will have reached just the right temperature for your baby. Remove the bottle or pot from the container, turn the control knob to ‘OFF’ and disconnect the bottle warmer from the mains.

Check the temperature of the contents on the back of the hand first before feeding it to the baby, to ensure that the temperature of the bottle contents are safe for your baby. If the temperature is too hot, use less water in the inside of the bottle warmer. In case the temperature is too low, use more water.

MAINTENANCE INSTRUCTIONS

Cleaning:
Disconnect the Baby Bottle Warmer from the mains socket (or the cigarette lighter socket) and allow it to cool down. Clean the container and the outside of the Baby Bottle Warmer with a damp cloth. Never immerse the Baby Bottle Warmer in water. Do not use cleaning or scouring agents.
Decalcify:
Hard water deposits must be removed. To do this use white vinegar only. Pour the vinegar into the tank at mid-level, allow to rest until the hard water deposits have been completely eliminated. Rinse well and wipe with a damp cloth.
Warning:
If a fault occurs, consult the Alecto service centre at WWW.ALECTO.NL Under no circumstances should you try to repair the Baby Bottle Warmer yourself; do not dismantle. Servicing should be performed by qualified service personnel only.

TECHNICAL SPECIFICATIONS

Power supply: 220-240V AC
Power consumption: 80 Watts
Operational ambient temperature: between +7ºC and +37ºC
Heating system: PTC with temperature controlled protection 24 months guarantee

Service Help
WWW.ALECTO.NL
SERVICE@ALECTO.NL
Hesdo, Australiëlaan 1
5232 BB, ‘s-Hertogenbosch
The Netherlands