CAKE Osa Plus Upper Windshield Instructions

June 9, 2024
cake

CAKE Osa Plus Upper Windshield

Osa Plus Upper Windshield

Installation Instructions

Installation Instructions

Items|

Instructions

---|---

| Assemble the spacers onto the windshield. Mount it to the bracket with the four torx screws.| Fasteners included
4x torx screws
4x hex screws
4x metal spacers
4x rubber spacers

| Remove the stem from the bike by removing the four screws. Install windshield using the four new hex screws.| Tools needed
Torx 20
Hexkey 5 mm

Installation Instructions

Items|

Instructions

---|---

| Insert spacers into holes in windshield. Mount windshield to
bracket using the four torx screws.| Fasteners included
4x torx screws
4x hex screws
4x metal spacers
4x rubber spacers

| Mount the bracket under the stem using the four bolts.
Tip: Make a full turn with the handlebar for better access to the screw holes.| Tools needed
Torx 20
Hexkey 5 mm

Installation Instructions

Items|

Instructions

---|---

| Install the clamps on the bike. The two small clamps goes on the skid plate, one on each side of the bike, and the big clamp goes on the down tube. Make sure that the big clamp is on the correct height. The hook should be on top of the edge. Apply loctite to all screws and tighten to 1ONm.| Fasteners included
4x flat head screw
2x M6 torx screw
2x M4 torx screw
2x M6 hex screw
2x washer 2x M4 nut
4x rubber spacer
4x metal spacer

| Insert the spacers into the holes in the windshields and install the mud flap using the two screws, washers and nuts.| Tools needed
Torx 20
Torx 30
Hex key 5 mm
Wrench 7 mm

| 3. Install the windshield on the bike by screwing it onto the clamps. Apply Loctite to all screws and tighten to 10Nm.

NOTE: If the Ösa has a :work front carrier, you must use the :work edition of the windshield with holes for the carrier elbows. The elbows does then have to be dismounted first and then reinstalled again after the windshield is in place.

Installation Instructions

Items|

Instructions

---|---

| Install the clamps on the bike. The two small clamps goes on the skid plate, one on each side of the bike, and the big clamp goes on the down tube. Make sure that the big clamp is on the correct height. The hook should be on top of the edge. Apply loctite to all screws and tighten to 1ONm.| Fasteners included
4x flat head screw
2x M6 torx screw
2x M4 torx screw
2x M6 hex screw
2x washer
2x M4 nut
4x rubber spacer
4x metal spacer

| Insert the spacers into the holes in the windshields and install the mud flap using the two screws, washers and nuts.| Tools needed
Torx 20
Torx 30
Hex key 5 mm
Wrench 7 mm

| Dismount the elbows of the front carrier. Then install the windshield on the bike by screwing it onto the clamps.
Reinstall the carrier elbows again after the windshield is in place. Apply Loctite to all screws and tighten

Please contact your local CAKE service center if you need support

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals