Blackburn 7149586 Grid 2 USB Rechargeable Front/Rear Light User Manual
- June 3, 2024
- Blackburn
Table of Contents
Blackburn 7149586 Grid 2 USB Rechargeable Front/Rear Light
QUICK START
- Push the button to power on.
- Double-click to switch between front and rear light modes.
- Single-Click to cycle modes.
- Hold 1 second to power off, light powers back on in the last mode used.
FUEL GAUGE
Color LEDs in the power button help you monitor your light battery power,
indicating that it’s time to charge your light.
USB CHARGING
Fully charge the light before first use. The fuel gauge will flash when
charging. When charging is complete the fuel gauge will be steady green.
*MODES front LUMENS RUNTIME AUTO-ECO**
- Solid 175 2h –
- Pulse 100 6h + 2h
- Strobe 40 7h + 2h
- ECO 40 25h –
*MODES REAR LUMENS RUNTIME AUTO-ECO**
- Solid 55 1.75h –
- Pulse 35 6h + 2h
- Strobe 20 6.5h + 2h
- ECO 20 22h –
Auto-eco switches on automatically at the end of Pulse and Strobe run times for an additional 2hrs of runtime.
MOUNTING
Pull the strap around the handlebar and attach to the hook. Fits most handlebars, seat posts, seat stays, racks, and bag light loops.
INCLUDES
(2) Li Po Battery, (1) Dual-head USB charging cable, (2) Silicone straps,(2)
Removable clip
Power button
Silicone straps
Dual-head cable USB-A to USB-C
WARNING
Potential choking hazard to children. This light is extremely bright—do not
aim directly into the eyes. UK ONLY: When used for cycling, this light should
be used in conjunction with a British Standard 6102/3 cycle light.
WARNING
This product contains Bisphenol A which is known to the State of California
to cause reproductive harm.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. Shielded interface cable must be used with the equipment in order to comply with the limits for a digital device pursuant to Subpart B of Part 15 of FCC Rules. Specifications and designs are subject to change without any notice or obligation on the part of the manufacturer.
Customer Service: 1-800-456-2355
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>