solis Type 577 VAC SMART Vacuum Sealer User Guide

: June 9, 2024
: solis

Table of Contents

Safety instructions regarding installation
Safety instructions regarding use
Safety instructions regarding maintenance
TECHNICAL SPECIFICATIONS
Documents / Resources

solis Type 577 VAC SMART Vacuum Sealer User Guide

Safety instructions regarding installation

WARNING

Do not drop the appliance and avoid bumping.
Place the appliance on a stable, flat, heat and moisture resistant surface.
Keep a minimum safety distance of 20 cm between the appliance and walls, curtains or other materials and objects and make sure that the air around the appliance can circulate freely.
Do not place the appliance in direct sunlight.
Before using the appliance, check that the voltage stated on the type plate of your appliance matches your mains voltage. Do not operate the appliancewith a multiway plug adapter.
Do not use a timer or a separate remote-control system that switches on the device automatically.
Do not leave the power cable hanging over table edges to prevent the appliance from being pulled down. Make sure that neither the appliance nor the power cord or plug comes into contact with hot surfaces, such as hotplates or a radiator, or that they come into contact with the appliance itself.
Never place the appliance in such a way that it is at risk of falling into water or coming into contact with water resp. other liquids (e.g. in or near a sink).
Never reach for an appliance that has fallen into water or other liquids:
- Always wear dry rubber gloves to unplug the appliance before taking it
  out of the water.
- Do not start using the appliance again before having it checked for functionality and safety by Solis or a service center authorized by Solis.
Do not place the appliance directly under a power outlet.
Switch off and unplug the appliance before moving the appliance.
Fully unwind the power cable before use.
Keep the appliance away from heat-emitting appliances or heat sources.
Keep the appliance away from moving parts or appliances.
Do not use an extension cable with this appliance.
Make sure the cover is not locked before inserting or removing the plug from a socket.

Safety instructions regarding use

WARNING

Children must be supervised to ensure that they not play with the appliance.
Do not operate the appliance with wet hands.
Only use the appliance with the provided accessories or accessories recommended by Solis. Incorrect accessories or misuse can lead to damage to the appliance.
Parts of the appliance may get hot during use. Only touch the control panel when using the appliance.
Do not move the appliance when in use.
Unplug the appliance when it is not in use.
Only use Solis vacuum films and bags, or containers that were designed for this appliance. Incorrect accessories or misuse can lead to damage to the appliance.
Never carry the appliance by the power cord.
Do not place anything on the power cord.
Never pull on the power cord to unplug the appliance. Only pull on the plug.
Do not insert sharp or pointed objects into the openings of the appliance. This may damage the appliance or result in electric shock.
Remove and discard all packaging materials and potential stickers or labels (except for the type plate) before using the appliance for the first time.
The sealing bar gets hot during use. Do not touch the sealing bar during or shortly after use.
Do not use the appliance continuously. Take at least a 1-minute break between vacuuming bags to prevent the motor from overheating.
Do not seal more than 30 bags in a row to prevent the appliance from overheating.
Always operate the appliance with clean hands.
During the vacuum process, make sure liquid is not sucked into the vacuum
chamber. If liquid is sucked into the vacuum chamber, this is collected by the drip tray. Remove and empty the drip tray. Wipe away the remaining liquid in the vacuum chamber.
Do not use oils or lubricants with this appliance. Lubricants and other liquids can lead to damage to the appliance.

Safety instructions regarding maintenance

WARNING

Switch off and unplug the appliance before service and when replacing parts.
Let the appliance cool down before cleaning.
Never immerse the appliance in water or place it in a dishwasher.
Do not use abrasive chemical cleaning agents such as ammonia, acid or acetone when cleaning the appliance. This can damage the appliance.
Do not make any adjustments to the appliance, cable, plug or accessories.

CONTENTS

1x VAC SMART

APPLIANCE DESCRIPTION (SEE IMAGE A)

Release buttons
Membrane keyboard
Cover
Locking catches
Upper and lower seal
Rubber contact strip
Canister switch button
Sealing bar
Vacuum chamber
Drip tray
Air extraction opening
Power cable in cable compartment

CONTROL BUTTONS (SEE IMAGE B)
VACUUM & SEAL button
CANCEL button
SEAL button

INSTALLATION

**** Make sure that the appliance and containers are clean and free of damage to prevent contaminating any food.

Place the appliance on a stable, flat, and heat and moisture resistant surface.
Make sure to have enough space around the appliance to process the bags with food.
Plug the power cable e into a power outlet. The appliance switches on. The indicator light at the VACUUM & SEAL button lights up blue.

CREATING A BAG FROM VACUUM FILCREATING A BAG FROM VACUUM FILMM

Cut the vacuum film to the desired size. The bag should be at least 10 cm larger than the food.
Pull up the release buttons 1.
Open the cover 3.
Place one open end of the vacuum film on the sealing bar 8. Do not let the vacuum film extend into the vacuum chamber 9.
Close the cover 3.
Push down the cover 3 until you hear a click on both sides of the appliance
Do not press the release buttons to close the cover.
Press the SEAL button y to seal the vacuum film.
The green indicator light flashes. The process is done when the light switches off.
Pull up the release buttons 1.
Open the cover 3.
Remove the vacuum film from the appliance. The vacuum film should now be shaped like a bag, with just one open end.
Check if the seal seam is straight and without creases. If this is not the case, cut off the seam and repeat the process.

VACUUMING AND SEALING A FILLED BAG

Pull up the release buttons 1.
Open the cover 3.
Fill a vacuum bag with food. The bag should be at least 10 cm larger than the food.
You can purchase accessories for your vacuum sealer at your supplier or Solis.
Clean the inside and outside of the open end of the bag.
Smooth out the open end of the bag. Make sure there are no wrinkles.
Place the open end of the bag inside the vacuum chamber 9.
Do not cover the air-extraction opening with the bag.
Push down the cover 3 until you hear a click on both sides of the appliance.
**** Do not press the release buttons to close the cover.
Press the VACUUM & SEAL button r to start the vacuum and sealing process
**** The high vacuum pressure in the bag may crush fragile food. To prevent this, press the SEAL button when the desired vacuum is achieved. The appliance stops vacuuming the bag and starts to seal the bag.
The blue indicator light flashes during the vacuuming process. When the process is finished the blue light burns continuously.
Pull up the release buttons 1.
Open the cover 3.
Remove the bag from the appliance.
Check if the seal seam is straight and without creases. If this is not the case, cut off the seam.

VACUUMING SOLIS CONTAINERS

Exclusively use containers from Solis with this appliance. You can purchase accessories for your vacuum sealer at your supplier or Solis.

Clean and dry the container thoroughly.
Place the food into the container. Leave at least 3 cm room between the food and the top of the container.
Clean the top of the container.
Place the container lid on the container.
For hexagonal containers with twist-knob lids, turn the twist-knob to the SEAL position.
Open the cover 3.
Use the vacuum hose which has been supplied with your Solis containers.
Insert one end of the vacuum hose into the air extraction opening w.
Insert the other end of the vacuum hose into the opening on the lid of the container.
Press the canister switch button 7. The vacuuming process begins.
Press down on the lid of the container during the vacuuming to prevent air from entering the container
The vacuuming process stops automatically when the required vacuum has been reached.
Gently pull out the vacuum hose from the lid.
To check if the container was successfully vacuumed, try to take the lid off. If the lid cannot be taken off, the vacuum pressure is good.
To open the lid of:

a hexagonal container with a twist-knob, turn the twist-knob to the OPEN position.
a square container without a twist-knob, press the button next to the air extraction opening.

If the container was successfully vacuumed, a hissing sound is audible when the container is opened

CLEANING THE VACUUM CONTAINERS

Do not immerse the lids of the containers into water.
Do not put the lids of the containers into a dishwasher.

Hand wash the containers without lids in warm water with dish soap.
Remove the inner cap on the underside of the container lid.
Wash the cap in warm water with dish soap.
Clean the container lid with a damp cloth.
Dry all parts thoroughly.
Re-insert the cap on the underside of the lid.
To keep the rubber seals elastic, rub them regularly with a few drops of cooking oil.

CLEANING AND CARE

Do not use abrasive chemical cleaning agents such as ammonia, acid or acetone when cleaning the appliance. This can damage the appliance.
Do not lubricate the appliance.

Unplug the appliance.
Let the appliance cool down.
Clean the appliance with a damp cloth.
Remove the drip tray q from vacuum chamber 9.
Clean the drip tray q thoroughly by hand in warm water with dish soap.
Remove the lower seal 5 from the appliance.
Clean the lower seal 5 in warm water with dish soap.
Let the lower seal 5 air dry.
Reinsert the drip tray q into the appliance.
Reinsert the lower seal 5. Make sure to insert the lower seal so that no air can get into the

vacuum chamber 9.

STORAGE

Roll up the power cable e and place it in the underside of the appliance.
**** Do not wrap the power cable around the appliance.
Store the appliance in the original packaging in a dry and enclosed space.
**** Do not place anything on top of the appliance.
Make sure there is no pressure on the seals.

Leave the locking mechanism unlocked.

TECHNICAL SPECIFICATIONS

Model-No.: Type 577
Voltage / frequency: 220–240 V~ / 50 Hz
Output: 110 W
Dimensions (W x D x H): 37 x 14.5 x 7 cm
Weight: 1.3 kg

QR Code

solis Logo

Documents / Resources

| solis Type 577 VAC SMART Vacuum Sealer [pdf] User Guide
Type 577, VAC SMART, Vacuum Sealer, VAC SMART Vacuum Sealer, Type 577 Vacuum Sealer, Type 577 VAC SMART Vacuum Sealer, Sealer
---|---