NXP MC56F80000 Evaluation Kit User Guide
- June 9, 2024
- NXP
Table of Contents
QUICK START GUIDE
MC56F80000-EVK
MC56F80000 EVALUATION KIT
GET TO KNOW THE MC56F80000-EVK
OPERATION NOTES
- MC56F80000-EVK can be powered by either of the USB connectors (J12, J26), or the adapter input (J7). Beware that only an adapter with 5V output can be used.
- When the board is powered up, a green LED D2 will illuminate, indicating 3.3V is on. If the board is powered by USB connector (J12), an orange LED D4 will also illuminate, indicating K26 is powered.
- J12 is the on-board OPENSDA (realized by K26) connector which can be used to debug/program MC56F80748. It provides a virtual serial port as well.
- J26 is the virtual serial port connector. CP210x USB to UART bridge VCP Drivers are needed. CP210x is not populated by default on the board.
- J10 is the JTAG connector for MC56F80748. Remember to remove four jumpers on J13 when this JTAG is used. This is to avoid the impact of on-board OPENSDA circuit.
- Pin2 and pin3 of J11 are connected by default to enable the external reset from SW1.
GET STARTED
Download installation software and documentation under “Jump Start Your
Design” at www.nxp.com/MC56F80000-EVK.
SUPPORT
Visit www.nxp.com/support for a list of phone numbers within your region.
WARRANTY
Visit www.nxp.com/warranty for complete warranty information.
NXP, the NXP logo and NXP SECURE CONNECTIONS FOR A SMARTER WORLD are trademarks of NXP B.V. All other product or service names are the property of their respective owners. © 2022 NXP B.V.
Document Number: MC56F80000QSG REV 0 Agile Number: 926- 54617 Rev A
References
- MC56F80000-EVK | NXP Semiconductors
- Support | NXP Semiconductors
- Returns and Warranty Information | NXP Semiconductors
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>