LANCOM OX-6400 Outdoor Access Points User Guide
- June 9, 2024
- LANCOM
Table of Contents
LANCOM OX-6400 Outdoor Access Points User Guide
Mounting
Screw the connector flange to the back of the housing with the four screws and their washers.
When fastening the clamp profile , please pay attention to tighten the screws equally with a maximum torque of 7 Nm!
Wall mounting
Use the mounting arm as a template. Fix the mounting arm to the wall with the
supplied screws and Dowling plugs.
Attach the access point with the connector flange to the mounting arm . Use
the M8x110 bolt with spring locking washer, washer and nut.
Pole mounting Place the clamp profile around the pole. Screw the clamp profile
onto the mounting arm with the supplied screws.
The main beam direction of the integrated antenna can be adjusted by tilting
the access point up or down by rotating the connection flange about the
mounting arm.
ETH1 (PoE), ETH2 (PoE passthrough) interfaces
The device is simultaneously supplied with power via the ETH1 (PoE)
connection. To do this, plug the supplied waterproof network cable into the
ETH1 (PoE) port and screw the cable carefully. Connect the other end of the
network cable to a free PoE-capable network socket of your local network or
with a PoE injector. Connect the ETH2 interface optionally to a device to be
supplied with power via PoE passthrough.
Reset button (part of the LED block)
To restore the device to its default configuration, keep the reset button on
the device pressed until the LEDs on the device go out. The following
automatic restart restores the default configuration to the device.
Grounding
Screw one end of the green/yellow grounding wire to the housing and attach the
other end to a suitable ground.
Before initial start up, please make sure to take notice of the information regarding the intended use in the enclosed installation guide!
Operate the device only with a professionally installed power supply at a nearby power socket that is freely accessible at all times.
Installing access points and/or external antennas without adequate lightning protection can lead to serious damage to the devices and/or to the related network infrastructure.
Please observe the following when setting up the device → The housing of
the device may become warm during operation.
→ If the device is operated with outside temperatures exceeding 60 °C, it
should be mounted with protection against contact.
→ When using customized outdoor Ethernet cables, make sure that the cables
have a short plug kink protection.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>