vita VA68894 Rosewood Arbor Installation Guide
- June 9, 2024
- Vita
Table of Contents
**vita VA68894 Rosewood Arbor Installation Guide
**
PARTS LIST
PRE-ASSEMBLED SIDE PANEL – 12004 – X2
**POST TRIM 12001 – X4
**
**ARCH KEYSTONE 12000 – X2
**
RIGHT ARCH – 12002 – X2
LEFT ARCH – 12043 – X2
WOOD BLOCK – X1
ARCH RAFTER – 12003 – X6
METAL GROUND STAKES – 12006 – X4
**20071 – SCREW A – 1 3/8IN (3.5CM) – X8 – TO SECURE POST TRIM CAPS TO ARBOR POSTS
**
**20064 – SCREW B – 1 1/4IN (3.18CM) – X8 – TO ATTACH METAL STAKES TO ARBOR
**
**20063 – SCREW C – 1 3/4IN (4.5CM) – X14 – TO ATTACH RAFTERS AND KEYSTONES TO
**
20065- BOLT AND T-NUT D – 2IN (5CM) – X8 **TO FASTEN SIDE PANELS TO ARCH ASSEMBLY. T-NUTS PRE INSTALLED
**
20067 – BOLT AND T-NUT E – 1 3/4IN (4.5CM) – X4 **FASTEN ARCH SECTIONS TOGETHER. T-NUTS PRE-INSTALLED
**
TOOLS YOU WILL NEED
PRODUCT DIMENSIONS
Temporary Installation
Carefully push arbor stakes into desired ground area
Permanent Installation
For a permanent installation, measure four 8in (20.3cm) holes in diameter, 44 1/2in (113cm) apart by 22in apart (56cm), from center to center. Dig each hole 14in (36cm) deep.
Fill excavated holes with mixed concrete and carefully lift arbor into place. Plumb and level the arbor. The posts should not be set in the concrete.
Make sure to support bottom part of you lattice with bricks until concrete has set. This will stop your arbor from sinking
8:00 AM – 5:00 PM EST
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>