HOMEWORKS BFP-272-V5.0 Replacement Bluetooth Speaker Kit Instruction Manual
- June 8, 2024
- HOMEWORKS
Table of Contents
BFP-272-V5.0 Replacement Bluetooth Speaker Kit
Instruction Manual Speaker model BFP-272-V5.0 for Bath Fan model
7130-33-BT
BFP-272-V5.0 Replacement Bluetooth Speaker Kit
Installation Instructions
Tools needed: Philips Screwdriver (+)
-
If the bath fan is installed, remove the grille by squeezing the mounting springs and pulling the grille down from the fan housing. Disconnect the connectors to remove the grille from the fan housing, as shown in Figure 1.
-
Note the placement of the speaker and how the wires are installed. You want your installation to look exactly the same when complete.
-
Using a screwdriver, remove the 8 screws holding the speaker in place, as shown in Figure 2. Retain the screws.
-
Unscrew the two screws for the bracket along the wire routing.
Removing this bracket will allow the wires to be removed from the grille. Retain the screws and bracket for re-installation later.
-
Gently slide the speaker and attached wiring out of the grille.
-
Insert the new speaker into the grille. Ensure the speaker wire is aligned with the bracket so the wire can be tucked underneath.
-
Align the screw holes. Reinstall the screws removed in step 3.
-
Tuck the speaker wire under the bracket and reattach with the two remaining screws.
-
Join the connectors for the Bluetooth® speaker and LED light from the fan housing to the grille, as shown in Figure 3. Attach the grille by pinching the mounting springs and inserting them into the narrow rectangular slots in the fan housing.
-
Turn on the power source. Test the unit.
If not operating properly, please contact customer service at 1-877-319-3757 or send an email message to Info@HWCares.com.
Homewerks.com
© 2021 Homewerks Worldwide, LLC
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>