SANGEAN SR-35 MW-FM 2-Band Radio Instruction Manual
- June 8, 2024
- Sangean
Table of Contents
Operating Instructions
SR-35
SR-35 MW-FM 2-Band Radio
Controls
- Volume On/Off control
- Power indicator
- Tuning LED indicator
- Tuning scale
- Tuning control
- Boss for hand strap
- Telescopic antenna
- Headphone socket
- Waveband switch
- Battery compartment
Power supply
To insert the battery, first open the battery cover by sliding it in the direction shown by the arrow. Insert two AA (LR6) size batteries into the compartment.
Headphone
Plug the headphone into the headphone socket for private listening.
This will disconnect the speaker.
Telescopic antenna
The telescopic antenna is for FM band reception. Extend and rotate it for best FM reception. There is a separate directional antenna built into the radio for AM reception. To achieve the best AM reception, it may be necessary to rotate the radio.
Volume On/Off control
Turn on the power by switching the Volume On/Off control switch.
Adjust it to the desired level of sound. Rotating the control clockwise will
increase the sound level.
Waveband switch
Set the waveband switch to the desired waveband.
Tuning control
Slowly rotate the tuning control to select the required station. The tuning indicator will light when the station is correctly tuned.
Tuning scale
Rotate the tuning control until the tuning scale corresponds to the frequency of the required station.
General maintenance
Do not allow this unit to be exposed to water, steam or sand. Do not leave the unit where excessive heat could damage such as in a parked car where the heat from the sun can build up even though the outside temperature may not seem too high.
Specifications
| Battery | 2 X AA (UM-3/LR6) size |
|---|---|
| Frequency coverage | FM 87.5 – 108 MHz |
AM 520 – 1710 kHz
Loudspeaker| 2 1/4 inches
Output Power| 120 mW 8 ohm
Headphone socket| 3.5mm dia. (mono)
3A81UE1000000
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>