Bauer 57932 16 Ft.Tile Flooring Laser Level Owner’s Manual
- June 4, 2024
- BAUER
Table of Contents
Bauer 57932 16 Ft.Tile Flooring Laser Level
When unpacking, make sure that the product is intact and undamaged. If any
parts are missing or broken, please call
1-888-866-5797 as soon as possible.
Read this material before using this product. Failure to do so can result in
serious injury. SAVE THIS MANUAL.
WARNING SYMBOLS AND DEFINITIONS
- This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death.
- Indicates a hazardous situation which, if not avoided, will result in death or serious injury.
- Indicates a hazardous situation which, if not avoided, could result in death or serious injury.
- Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
- Addresses practices not related to personal injury.
IMPORTANT SAFETY INFORMATION
Safety Warnings and Precautions
Read all safety warnings and all instructions. Failure to follow the warnings
and instructions may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
-
Never attach or use any other form of optical device with this product. Use as intended only.
-
Do not modify in any way as this may result in hazardous radiation exposure.
-
This product is not a toy. Do not allow children to play with or near this item.
-
Inspect before every use; do not use if parts are loose or damaged.
-
Avoid damaging Laser Level. Use only as specified in this manual.
-
Power this Laser Level using only the batteries referenced in the Specifications Chart.
-
Stay alert. Watch what you are doing, use common sense. Do not operate any Laser Level when you are tired.
-
Do not operate Laser Level if under the influence of alcohol or drugs.
Read warning labels on prescriptions to determine if your judgment or reflexes are impaired while taking drugs. If there is any doubt, do not operate the Laser Level. -
Do not look into laser. Do not point laser at persons or animals directly or indirectly off of reflective surfaces.
-
Performance of this Laser Level may vary depending on battery condition.
-
The Laser Level is a delicate instrument; do not drop or jar the Laser Level.
-
Maintain product labels and nameplates. These carry important safety information. If unreadable or missing, contact Harbor Freight Tools for a replacement.
-
Do not install old and new batteries together. Do not install alkaline, carbon-zinc or rechargeable batteries together. Position batteries in proper polarity. Do not use swollen or leaking batteries.
-
Do not attempt to charge batteries
-
Have the Laser Level calibrated by a qualified technician every year to maintain accurate results.
-
People with pacemakers should consult their physician(s) before use. Electromagnetic fields in close proximity to heart pacemaker could cause pacemaker interference
or pacemaker failure. -
The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors that cannot be built into this product, but must be supplied by the operator.
Specifications
| Working Range | Up to 16.4 ft (5 meters) |
|---|---|
| Accuracy | ± 0.5mm/m (± 3/16″ @ 33 ft) |
| Battery | 2x AA (Included) |
| Operating Temperature | 32°F – 104°F (0°C – 40°C) |
| Operating Environment | Indoors |
Setup – Before Use
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of
this manual including all text under subheadings therein before set up or use
of this product.
Functions
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
General Operation
-
Install batteries as described in “Battery Replacement” on page 7.
-
Set the Level on a flat, level surface.
-
To mark guidelines:
-
Place the bottom on the Level on the floor or wall. Press the Power Switch to turn on the laser.
-
Place the T-Edge against a wall so that the laser lines run parallel to reference lines.
-
If on the wall, align the Level so that the 0° Alignment Bubble is level and the 90° Alignment Bubble is at the top.
-
If on the floor, align the Level so that both Alignment Bubbles are level.
-
To lay tiles on the floor:
-
Position Level in a corner so that laser lines run parallel to the reference lines as shown in Step 3.
-
Lay the first tile so that the sides are flush with the 0° and 90° laser lines.
-
If laying next to an edge, position the Level so that the T-Edge is against the side of the edge.
The 90° laser line should run parallel to the edge and the 0° laser line marks the tile row. -
To apply tiles to a wall:
-
Determine the height at which the first tile row should begin and mark the wall using the ruler on the Level or other measuring device.
-
Place the T-Edge at the mark and straighten the Level so that the 0°laser line is parallel with the floor.
-
To check the alignment of a row of tiles, place L-Edge at the corner of a tile.
-
To check the alignment of a single tile, place the Level’s edge on top of the tile as shown below.
-
When finished with the Level, press the Power Switch to turn it OFF. Store Level in a dry indoor area away from children, If storing for a long period, remove the batteries.
Maintenance and Servicing
Procedures not specifically explained in this manual must be performed only by a qualified technician.
Cleaning, Maintenance, and Lubrication
- Wipe unit with a dry, lint-free cloth. Do not use solvents or abrasives.
- Remove batteries if not in use for long periods.
- Store unit in a dry location.
- Other than the batteries, there are no replaceable parts on this unit. Repairs should be done by a qualified technician.
Battery Replacement
- Turn the Level’s Power Switch OFF.
- Remove battery cover by pressing the Latch and removing the cover.
- Remove old batteries. Replace with new AA batteries follow polarity.
- Replace battery cover and be sure the Latch connects securely.
Note : Do not install old and new batteries together. Do not install alkaline, carbon-zinc or rechargeable batteries together. Position batteries in proper polarity. Do not use swollen or leaking batteries.
Calibration
Have the Laser Level calibrated by a qualified technician every year.
Record Serial Number Here
- Note: If product has no serial number, record month and year of purchase instead.
- Note: Replacement parts are not available for this item.
Reference UPC 193175427045.
Limited 90 Day Warranty
Harbor Freight Tools Co. makes every effort to assure that its products meet
high quality and durability standards, and warrants to the original purchaser
that this product is free from defects in materials and workmanship for the
period
of 90 days from the date of purchase. This warranty does not apply to damage
due directly or indirectly, to misuse, abuse, negligence or accidents, repairs
or alterations outside our facilities, criminal activity, improper
installation, normal wear and tear, or to lack of maintenance. We shall in no
event be liable for death, injuries to persons or property, or for incidental,
contingent, special or consequential damages arising from the use of our
product. Some states do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation of exclusion may not apply to
you. THIS WARRANTY IS EXPRESSLY IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR
IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS.
To take advantage of this warranty, the product or part must be returned to us
with transportation charges prepaid. Proof of purchase date and an explanation
of the complaint must accompany the merchandise. If our inspection verifies
the defect, we will either repair or replace the product at our election or we
may elect to refund the purchase price if we cannot readily and quickly
provide you with a replacement. We will return repaired products at our
expense, but if we determine there is no defect, or that the defect resulted
from causes not within the scope of our warranty, then you must bear the cost
of returning the product.
This warranty gives you specific legal rights and you may also
have other rights which vary from state to state.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>