KICHLER 52259CLP Voclain 6-in 1-Light Brushed Nickel Vintage Vanity Light Instruction Manual
- June 8, 2024
- KICHLER
Table of Contents
KICHLER 52259CLP Voclain 6-in 1-Light Brushed Nickel Vintage Vanity Light
Fixture Diagram
Parts List
[A] Mounting Strap
[B] Outlet Box
[C] Mounting Screws
[D] Canopy
[E] Strap Mounting Screws
[F] Lockup Knobs
Cautions
CAUTION – RISK OF SHOCK –
Disconnect Power at the main circuit breaker panel or main fuse box before
starting and during the installation.
WARNING :
This fixture is intended for installation in accordance with the National
Electrical Code (NEC) and all local code specifications. If you are not
familiar with code requirements, installation by a certified electrician is
recommended.
CLEANING:
Always be certain that electric current is turned off before cleaning.
- Only a soft damp cloth should be used. Harsh cleaning products may damage the finish.
Installation Instructions
-
Find the appropriate threaded holes on mounting strap[A] that align with hole distance in canopy[D] Thread mounting screws[C] into threaded holes starting from outlet box[B] side.
-
Attach mounting strap[A] to outlet box[B] using the strap mounting screws[E]. Mounting strap can be adjusted to suit position of fixture.
-
Grounding instructions: (See Illus. a or b).
a) On fixtures where mounting strap is provided with a hole and two raised dimples, wrap ground wire from outlet box around green ground screw, and thread into hole.
b) On fixtures where a cupped washer is provided, attach ground wire from outlet box under cupped washer and green ground screw, and thread into mounting strap.
If fixture is provided with ground wire, connect fixture ground wire to outlet box ground wire with wire connector after following the above steps. Never connect ground wire to black or white power supply wires.
-
Make wire connections. Reference chart below for correct connections and wire accordingly.
Connect Black or Red Supply Wire to:| Connect White Supply Wire to:
---|---
Black| White
Parallel cord (round & smooth)| Parallel cord (square & ridged)
Clear, Brown, Gold or Black without Tracer| Clear, Brown, Gold or Black with Tracer
Insulated wire (other than green) with copper conductor| Insulated wire (other than green) with silver conductor
*Note: When parallel wire (SPT 1 & SPT 2) are used. The neutral wire is square shaped or ridged and the other wire will be round in shape or smooth (See illus.
- Push fixture to wall carefully aligning the mounting screws with holes in canopy. Make sure all wires are inside canopy and do not get pinched between canopy and wall.
- Thread lockup knobs [F] onto mounting screws and tighten to secure fixture to wall.
- Insert recommended bulbs (not supplied).
For warranty information please visit:kichler.com/warranty
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>