Q-SYS TSC-50t-G3 Tabletop Stand Accessory User Guide
- June 8, 2024
- q-sys
Table of Contents
Q-SYS TSC-50t-G3 Tabletop Stand Accessory
Tabletop Stand Accessory
TSC-50t-G3 (for TSC-50-G3)
TSC-710t-G3 (for TSC-70-G3 or TSC-101-G3) QSC Self Help Portal
Read knowledge base articles and discussions, download software and firmware,
view product documents and training videos, and create support cases.
https://qscprod.force.com/selfhelpportal/s/
Customer Support
Refer to the Contact Us page on the QSC website for Technical Support and
Customer Care, including their phone numbers and hours of operation.
https://www.qsc.com/contact-us/
Warranty
For a copy of the QSC Limited Warranty, visit the QSC, LLC., website at www.qsc.com.
Tabletop Features
- Tool-less assembly
- Portrait and landscape configurations
- Movable or fixed installation options
- Non-skid, low profile design
Specifications
- Dimensioned drawings and product specifications available online at www.qsc.com.
- QSC recommends using a category cable without a moulded strain relief boot. Refer to the Hardware User Manual for other cable requirements.
Movable Installation
TSC-50t-G3 / TSC-710t-G3
Caution: Do not attempt to assemble or disassemble the stand while the
touch screen controller is attached.
-
Orient Docking Plate 1 (TSC-50t-G3 Only)
-
Remove Base 2 ( Method 1 )
(Method 2) -
Route Cable
-
Install Base
-
Connect Cable to Touchscreen Controller
Fixed Installation
TSC-50t-G3 / TSC-710t-G3
User Supplied Parts
These parts are required only for the fixed installation.
- Lock/Jam Nut (or Similar)
- Mounting Pipe (3/4″ NPS)
- Rubber/Foam Washer (Optional)
Assembly and Installation
- Orient Docking Plate 1 (TSC-50t-G3 Only)
- Drill Hole
- Install Threaded Pipe
- Route Cable
- Connect Cable to Touchscreen Controller
- Assemble Touchscreen Controller to Stand
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>