LAND ROVER Defender Td5 Small Rectangular Switches User Guide
- June 8, 2024
- LAND ROVER
Table of Contents
LAND ROVER Defender Td5 Small Rectangular Switches
This guide refers to the small rectangular switches found in the Defender Td5
dashboard and Defender Tdci/Puma dashboard. Guides and resources for the
Electric window and Hazard switches can be found within their individual
product pages on the MUD UK website. 
Before continuing, please remember
- This diagram is for reference only. Wiring colours are for reference and display only.
- This document is only to be used as a guide. Remember re-wiring any vehicle can be a huge undertaking and appropriate research beyond this document should be undertaken. If in doubt always seek advice from a qualified auto-electrician.
Housing Connectors
You’ll need to use the correct Land Rover housing connector in conjunction with your switch.
- There are 4 different coloured 5-pin connectors used in the Defender. Coloured connectors are keyed to their respective switches and are therefore not interchangeable between the switches. It is however possible to adapt the connectors by removing the keyways from them. We would always recommend using the correct colour for each switch wherever possible.
- We have listed which colour connector you need for which switch within the product pages of the website.
- Please also note that the colour of the connector does not affect which wiring scheme you follow.
Wiring the switch
There are two different ways to wire the Defender switches. The most common mistake by far when adding or re-wiring switches is to use the wrong circuit. Please make sure you use the information below to correctly identify which wiring scheme to use. Remember the colour of the housing connector does not have any relevance when it comes to wiring the switch.
The switch is not a load-carrying switch and a 30amp relay must be used in all applications. Make sure that the correct wire grade and good electrical guidelines are followed to prevent damage to electrical and electronic components. Always adequately insulate & secure any wiring to prevent short circuits.
The following switches switch the Earth/Ground Circuit (Defender Td5/Tdci unless otherwise stated)
- Rear Wiper YUG000350LNF
- Fog YUG000530LNF
- Heated Windscreen
- Rear Wash-Wipe YUE000070LNF
- Front Fog YUG000540LNF
- YUG000460LN
- Pin 1 – From the earth side of the Relay (Pin 85)
- Pin 2 – Dash/ sidelight illumination- green illumination
- Pin 3 – Not used (internally connected to 4)
- Pin 4 – Earth
- Pin 5 – Live from the accessory side of the relay (Pin 87)- amber off/on illumination controlled by relay
If you are considering using a genuine Land Rover switch but just require the body of the switch to use in conjunction with the Bearmach range of switch rockers then the following switches switch the positive live circuit and are generally easier to install than the earth/ground switches. As such these switches are harder to source and a few of them are now obsolete at Land Rover.
The following switches switch the Positive/Live Circuit (Defender Td5/Tdci unless otherwise stated)
- Heated Rear Screen YUG000470LNF
- Td5 Heated Seat switch RH YUG102440
- Air Conditioning JTB500010
- Td5 Heated Seat switch LH YUG102430
- Heated Seat Switch YUF500150LNF
Discovery 2 Heated Seat switches YUG102430, YUG102440, YUF500050PUY, YUF500080PUY.
- Pin 1 – Live in from the fused supply
- Pin 2 – Dash/ sidelight illumination- green illumination
- Pin 3 – Not used (internally connected to 5)
- Pin 4 – Switched live out to accessory/ relay
- Pin 5 – Earth
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>