baby trend WK38D35S Orby Activity Walker Instruction Manual

: June 8, 2024
: baby trend

Table of Contents

baby trend WK38D35S Orby Activity Walker
WARRANTY
PARTS
TO ASSEMBLE ACTIVITY TRAY
- Battery Installation
- TO FOLD WALKER
INFORMATION
- PLACING CHILD IN THE WALKER
- FCC Statement
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

baby trend WK38D35S Orby Activity Walker

Read all instructions BEFORE assembly and USE of product. KEEP INSTRUCTIONS FOR FUTURE USE.

WARRANTY

DO NOT RETURN YOUR PRODUCT TO THE STORE. PLEASE CONTACT BABY TREND® FOR REPLACEMENT PARTS, SERVICE AND REPAIR.
The Baby Trend® warranty covers workmanship defects within 1 year of purchase. Any product which has been subjected to misuse, abuse, abnormal use, excessive wear and tear, improper assembly, negligence, environmental exposure, alteration or accident, or has had its serial number altered or removed invalidates all claims against the manufacturer. Any damage to property during installation is the sole responsibility of the end user. Customer Service Department can be contacted at 1 800-328-7363 Monday through Friday between 8:00 a.m. and 4:30 p.m. (PST). Return Authorizations are required prior to returning product(s) to Baby Trend®. Please visit http://babytrend.com/pages/limited-warranty for complete warranty details.

WARNING: Please read all instructions before assembly and use of the walker. Keep instructions for future use.
WARNING: Never leave child unattended. Always Keep child in view while in walker.
WARNING: Use only on flat surfaces free of objects that could cause the walker to tip over.
WARNING: To reduce chance of child slipping out of the seat, check that both feet of the child touch the floor. Never carry walker with the child in it, as the child may get hurt or slip out.
WARNING: To avoid burns, keep the child away from hot liquids, ranges, radiators, space heaters, fireplaces, etc.
WARNING – STAIR HAZARD Avoid serious injury or death, block stairs/steps securely before using walker.

This walker is to be used only by infants, who are old enough to sit upright on their own and are ready to learn to walk (about 6 months old). DO NOT USE UNTIL BABY CAN SIT UP BY ITSELF.
Discontinue using the walker when the child can walk unassisted, reaches 30 lb. in weight, or reaches 32 inches in height.
DO NOT ADJUST TRAY HEIGHT WITH THE BABY IN THE WALKER.
Periodically inspect seat pad plastic tabs to be sure they are secured in the body. DO NOT USE THE WALKER IF IT IS DAMAGED OR BROKEN. Discontinue using should any part become damaged. Please contact our customer service at 1-800-328-7363 to order replacement parts or arrange for repairs.
Clean the stoppers on walker base regularly to maintain stopping performance. To clean the seat pad, use only mild household soap and warm water with a sponge or cloth. DO NOT MACHINE WASH. For metal and plastic parts, use only lukewarm water and mild soap.

If you experience any difficulty with assembly, missing parts or use, please DO NOT return this item to the store. Retail stores are unable to properly assist you. Contact our Customer Service Department directly for assistance. Call toll-free 1-800-328-7363, Monday – Friday, between the hours of 8:00 a.m. and 4:30 p.m. (PST).

PARTS

Check that you have all the parts for this model before assembling the stroller.

ASSEMBLY

IMPORTANT! To ensure safe operation of your product, please follow these instructions carefully. Please keep these instructions for future reference.
IMPORTANT! Before assembly and each use, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. NEVER use if any parts are missing or broken.
IMPORTANT! Adult assembly is required.
IMPORTANT! Always check that the baby walker is locked in the open position before using.
IMPORTANT! Carefully remove parts from box. Check that you have all the parts for this model before assembling the baby walker.

TO ASSEMBLE WALKER

To open the baby walker raise the tray up until the walker clicks into position (Fig. 1).
The baby walker can be used for 3 different heights. From underneath the front of the walker, turn the safety button right and slide vertically to adjust the height (Fig. 2).
Check that the safety button is turned horizontally to prevent the accidental release of the mechanism (Fig. 3).
Connect the seat fabric by inserting the plastic button pins into the upper, larger openings. Then push them firmly downwards until they SNAP into position (Fig. 4).
NOTE: Push the pins from the top of the opening all the way down to the bottom.
Locate the straps with plastic buckles on back of seat and corresponding slots on tray. Insert each strap into corresponding slot (Fig 5).

From the underside of tray pull each strap completely through each slot and pivot plastic buckle to lay flat against underside of tray (Fig. 6).

Underneath the walker, thread the end of the support strap through the loop on the seat bottom. Slip the strap through the slot at the end of the height adjustment bracket (Fig. 7).
Next thread the support strap through the opening in the rectangular ring and pull snug (Fig. 8).

TO REMOVE THE SEAT FABRIC

To remove the seat fabric reverse steps 7 and 8 first followed by the reversal of steps 4 through 6.
Place walker on a solid flat surface with bottom of base facing upward. Insert the pins of the front wheels into their housing, pressing them until they snap into position. Please check that wheels are locked into place before proceeding (Fig. 10).
Insert the pins of the rear wheels into their housing, pressing them until they snap into position. Please check that wheels are locked into place before proceeding (Fig. 11).

TO ASSEMBLE ACTIVITY TRAY

Battery Installation

The music unit requires three size AA batteries (not included). It is recommended that you use alkaline batteries for longer battery life.

CAUTION: To prevent possible battery leakage, be sure to follow the guidelines outlined below.

Do not mix old and new batteries.
Do not mix different types (alkaline, standard, or rechargeable).
Keep batteries out of reach of children.
Always dispose of batteries properly.
Remove batteries when the bouncer is not in use for long periods of time.
Never leave exhausted batteries in the unit.
Never try to recharge non-rechargeable batteries.

The activity tray requires 3 AA batteries. Please see figure 9 for battery installation. Unclip the battery door and pull outward. Install batteries as shown. Re-install battery door and push until it clicks into place.

To attach the activity tray, set the activity tray into the walker tray.
Push firmly on all sides until the activity center clicks in to place (Fig. 13). Do not use the activity tray if it has been damaged or broken.
Periodically check to see if the activity center is locked into place by pulling up on the activity center.

TO FOLD WALKER

To fold the walker, turn the button right to unlock and push it to release. Then push the tray downward (Fig. 14).

INFORMATION

PLACING CHILD IN THE WALKER

WARNING: To reduce chance of child slipping out of the seat, check that both feet of the child touch the floor. Never carry walker with the child in it, as the child may get hurt or slip out.

Always check the walker prior to each use to ensure that the seat is snapped in place and that the walker has no loose or broken parts. Do Not use the walker if it is damaged or broken or missing parts.
Before placing your child in the walker, please determine that your child is developmentally ready for this type of product. Generally, your child must be able to sit upright unassisted and have adequate neck strength to exhibit very good control of his or her head. Typically, a child should be at least 6 months of age to use this product. Infants develop at different rates and you should discuss the use of a walker with your pediatrician to ensure that your infant is ready.
Adjust the seat height of the walker to the lowest setting. Place your child in the walker and check that both feet touch the floor. The child should have only part of their weight on their feet when their legs are straight. Adjust the walker height as needed as your child grows. Do not adjust height with child in the walker. Discontinue using the walker if your child attempts to climb out, reaches 30 pounds in weight or 32 inches in height, or when your child is able to walk unassisted.
The baby walker can be used for 3 different heights. To adjust height, remove baby from walker. Adjustment instructions can be referenced in step 2. Adjust to desired height.
When the position has been selected, check that the safety button turned through 90 degrees to prevent the accidental release of the mechanism. Always follow this procedure. Never use the baby walker if the button is not in the sideways position. Important: Never change the height when the baby is in the walker.

FCC Statement

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:

This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired operation.

WARNING: Changes or modiﬁcations to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

BABY TREND® CUSTOMER SERVICE
The Customer Service Department can be contacted at 1 800-328-7363 Monday through Friday between 8:00 a.m – 4:30 p.m (PST). Return Authorizations are required prior to returning product(s) to Baby Trend®.