EKO K720P HD 720P Projector Instruction Manual

: June 8, 2024
: EKO

EKO K720P HD 720P Projector

K720P HD 720P Projector

GENERAL SAFETY

Read this manual thoroughly before you start using the Projector.
Store this manual, the completed warranty card, your receipt and the product packaging.
The safety precautions instructions reduces the risk of fire, electric shock and injury when correctly complied to.
Please follow all instructions and take notice of all warnings.

IMPORTANT INFORMATION

Only using furniture that can safely support the Products.
Ensure the Product is not overhanging the edge of the supporting furniture.
Do not place the product on a high furniture without securing both the furniture and the product to a stable support.
Do not place the product on cloth or other conductive materials.
Warn children of the dangers of climbing on furniture to reach the projector or its controls and to call for an adult to assist.
Do not expose this appliance to rain or moisture as it may result in fire or an electric shock hazard
Do not tamper or change or modify the product in any way.
Only use Accessories outlined and recommended by the manufacturer.
Please do not expose the product to splashing or water contact
Please do not place any object on top of the product including objects filled with liquids such as vases.
Replace with same or equivalent type.

Installation

Please follow instruction when installing this product in accordance with the instruction manual. This product must be positioned in a sufficiently stable location, it can be potentially hazardous due to falling and can cause injury, particularly to children if it positioned incorrectly

Before installing this Projector set, make sure your outlet voltage corresponds to the voltage stated on the product rating label
Do not use a damaged power cord, plug or loose outlet. Doing so may cause an electric shock.
Do not plug several devices into the same outlet. Doing so may cause the outlet to overheat and start a fire. Make sure the outlet is readily accessible during operation of the equipment.
Do not bend, twist or kink the power cord excessively.
Do not allow anything to rest on or roll over the power cord.
Doing so may cause a fire or an electric shock.
Do not run the power cord near heat-producing appliances such as radiators, stoves or irons. The excessive heat could melt the insulation and expose live wires, resulting in fire or electric shock.
Unplug this Projector during lightning storms or when unused for long periods of time. Not doing so may result in fire or electric shock.
Do not cover the ventilation openings of the product with items such as newspapers, tablecloths, curtains etc or insert objects into the slots available on the products.
As this could result in the product temperature rising and could cause a fire
If you notice any unusual odors or smoke around the unit, immediately disconnect the unit from the outlet and contact the service center. Failure to do so may result in fire or electric shock.
When not using the unit for long periods of time or when you are moving the unit please ensure to disconnect the power cord from the wall socket. GENERAL SAFETY (CONT.)
Please beware that Dust could accumulate over time on the unit and cause it to generate heat and or deteriorate insulation, which in turn may result in an electrical fire.
The product is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or young children of any age, They must be supervised product by a person responsible for their safety.
Batteries from the remote control must be only removed by an adult, the adult must ensure to keep them out of reach of infants and children. Seek medical attention immediately if a child has swallowed a battery.
Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like.
To maintain the product do not use any chemical or cleaning agent or wet cloth, please only ensure to utilize a dry cloth to wipe it down from marks or dust and only after unplugging the product from the power socket.
Please ensure to contact our call center for any repair or service required for the products.

! CAUTION !
DO NOT look directly into Project LENS. This can cause damage to a persons or childrens eyes. Take all nessecary precautions to make sure that no one looks into the LENS while turned on.
MAKE SURE this project is out of reach of children or baby so that they do not stand and look into the project LENS.
DO NOT cover the vents, the vents are needed to let out hot air. Placing objects near or covering the vents can cause the product to overheat and permenantly damage the projector.

Please make sure upon positioning this product, the place is:

Not wet or damp and Well ventilated
Away from direct sunlight or heaters.
Away from splashes or food.
Protected from excessive dust or grease.
Do not install this equipment in a confined space such as a bookcase or similar unit.
Do not install the Projector set near heat sources such as radiators, stoves or other audio visual equipment that produce heat.
Do not place containers with liquids, if liquid falls inside the products it may result in short-circuit, fire or electric shock.
Do not place small metallic objects on top of the unit. Metal object falls inside the product it may result in short-circuit, fire or electric shock.
Do not use or store flammable or combustible materials near the unit. Doing so may result in fire or explosion. Do not place any naked flame sources, such as lit candles, cigarettes or incense sticks on top of the Projector set.
Install the unit at a reasonable distance from the wall to ensure sufficient ventilation.

HDMI “HDMI, the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC.

PRODUCT OVERVIEW

TOP VIEW

Product Overview
① POWER
② UP
③ RIGHT
④ DOWN
⑤ LEFT
⑥ OK

SIDE VIEW

Product Overview
① DC POWER INPUT
② USB PORT
③ HD PORT
④ MICRO SD
⑤ AUDIO JACK

REMOTE CONTROL

Your projector comes with a Remote Control to access and control your projector from a distance. (Batteries not included).

Make sure to place the batteries into the back compartment of the remote control in the correct way.
The polarities on the battery (+/-) must match the polarities on the remote control in order for the remote to work.

Using the Remote Control

Do not mix old and new batteries in the remote
Do not use different types of battery
If you do not intend to use the unit for a long time, please remove batteries from the remote to avoid accident.
Keep batteries away from children and pets.
Never throw batteries into a fire.
Do not drop, or impact the remote control as it void warranty immediately.
The remote control operate at a range of 5 to 6M effectively
Do not expose the remote control sensor to a bright light.

FIRST TIME SETUP

Make sure to place the projector on a flat and stable surface that is level. So that the projector projects the video/image onto the wall nice and straight.

Plug in the Power cable into the DC Port of the Projector. Then plug in the other end into a wall power socket.
Once the power is plugged in, Press the button located at the top to turn on the projector.
You can now need to connect a source of media to play from to project onto the wall. This can be through:
a. HDMI
b. USB
c. SD
When you plug in a media source, you must select the INPUT source you want to view. By doing this, press the button for the INPUT menu to appear, then navigate with the arrow buttons, and press the Circle button to select the INPUT.
Once you have selected the INPUT, you can now adjust the VOLUME and manually adjust the focus of the projector lens to suite your needs depending on the distance from the wall your projector is.

PLEASE FOLLOW THE NEXT STEPS ON HOW TO MANUALLY ADJUST THE FOCUS.

PROJECTOR LENS FOCUS

Once you have your Projector all setup, input mode selected, power turned on.
You can now adjust the focus depending on the distance from your projector to the wall.

Turn the FOCUS dial to adjust the LENS focus.
LEFT DIRECTION – Is toward larger screen sizes best focus point.
RIGHT DIRECTION – Is towards smaller screen sizes best focus point.

This is the main menu dashboard that appears when you turn on your projector.
Below you have options to choose from:

Home
Music
Text
Movie
Photo
DMI
Settings

SETTING – PICTURE

To Access the setting PICTURE menu:

Press the MENU button located on the on the Remote Control.
With the directional keys, go to SETTINGS located on bottom right corner.
Press the RIGHT arrow button until you get to PICTURE.

SETTING – SOUND

To Access the setting SOUND menu:

Press the MENU button located on the on the Remote Control.
With the directional keys, go to SETTINGS located on bottom right corner.
Press the RIGHT arrow button until you get to SOUND.

SETTING – TIME

To Access the setting TIME menu:

Press the MENU button located on the on the Remote Control.
With the directional keys, go to SETTINGS located on bottom right corner.
Press the RIGHT arrow button until you get to TIME.

SETTING – OPTION

To Access the setting OPTION menu:

Press the MENU button located on the on the Remote Control.
With the directional keys, go to SETTINGS located on bottom right corner.
Press the RIGHT arrow button until you get to OPTION.

SPECIFICATIONS

DISPLAY	Supports up to 1080p (1920×1080)
Resolution	1280 x 720 Native Resolution
Contrast ratio:	2000 : 1
Projection Distance	1 – 3.9 Metres
Projection Size	50” to 120” (inches)
Lumens	100 ANSI
Aspect Ratio	16:9, 4:3