EUROM 851458 Electric Transfer Pump Instructions
- June 8, 2024
- EUROM
Table of Contents
EUROM 851458 Electric Transfer Pump
Please read this instruction leaflet carefully and completely before use
and follow the instructions closely.
Before use:
- Place 2 x AA -1.5V batteries (B) in the battery compartment (C). Pay attention to the polarity and only use batteries of the same type, charge level and capacity. Close the battery compartment again carefully with the sliding cover.
- Check whether the drainage hose (D) is correctly fitted to the pump (E) and whether the switch (A) is set to OFF.
Operation:
- Check the complete device for damage, cracks or holes in the drainage hose, before using the pump. Do not use a damaged device.
- Insert the tubing (F) in the fluid of the supplying tank (G).
- The nozzle with the sensor (I) in it is at the extremity of the drainage hose (D). Place it into the receiving tank (H), see fig.
- Now set the switch (A) to ON. The pump starts operating and will stop automatically if the tank (H) is filled up to the sensor level. If you wish to stop earlier, you can set the switch back to OFF. Check the operation only is the tubing has been dipped into the fluid.
- This pump is suitable for pumping petrol, kerosene, diesel, light oil types and water (not drinking water).
Warnings:
- Never let the pump run dry
- Do not use it for thinner or other solvents
- Do not pump any fluids warmer than 45°C or cooler than -5°C.
- Do not put the pump away upside down but with the suction side down after use.
- Remove the batteries if you do not use the pump for an extended period.
Transfer pump
| Power | Temp. of fluid | Battery | Dimensions & weight |
|---|---|---|---|
| 9 l/m | -5°C – +45°C | 2 x AA (1,5V) | 53,5 x 67 cm, 204 gr. |
Customer Support
EUROMAC BV., Kokosstraat 20, 8281 JC Genemuiden
e-mail: info@euromac.nl
www.eurom.nl
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>