VIMAR 01401 Smart Automation By-Me Plus Instruction Manual
- June 8, 2024
- VIMAR
Table of Contents
VIMAR 01401 Smart Automation By-Me Plus
Power unit with output 29 V d.c. 1280 mA, power supply 120-230 V~ 50-60 Hz, with decoupling coil, installation on DIN rails (60715 TH35), occupies 8 modules.
Power unit with decoupling coil. At most 2 power units can be installed on each line.
Read the instructions before installation and/or use.
CHARACTERISTICS
- Power: 120-230 V~ 50-60 Hz
- Consumption:
- 120 V: 700 mA
- 230 V: 450 mA
- Dissipated power: 9 W
- BUS output voltage: 29 V d.c. (SELV) with decoupling coil
- AUX output voltage: 29 V d.c. (SELV)
- Total max output current: 1280 mA (IBUS + IAUX)
- Operating temperature: -5 °C – +45 °C (from inside)
- 8 modules size 17.5 mm; installation on consumer units with DIN rails (60715 TH35)
- Installation for CAT II overvoltage category
- Symbol for class II devices with functional earth
INSTALLATION RULES
Installation should be carried out by qualified personnel in compliance with the current regulations regarding the installation of electrical equipment in the country where the products are installed. There must be no dripping or splashes of water on the appliance.
- Install the device at a height of no more than 2 m.
- An SPD (surge protection device) must be installed upstream from the device, in order to reduce the overvoltage category from III to II.
WARNING: To prevent injury, the appliance must be secured to the wall as described in the installation instructions. Above the power supply there must be a bipolar circuit breaker that is easily accessible with a contact gap of at least 3 mm.
CONFORMITY
LV directive. EMC directive. RoHS directive.
Standards EN 62368-1, EN 61000-6-3, EN 50130-4, EN 50491, EN 50581.
REACH (EU) Regulation no. 1907/2006 – Art.33.
The product may contain traces of lead.
FRONT VIEW AND CONNECTIONS
WEEE – Information for users
If the crossed-out bin symbol appears on the equipment or packaging, this
means the product must not be included with other general waste at the end of
its working life. The user must take the worn product to a sorted waste
center, or return it to the retailer when purchasing a new one. Products for
disposal can be consigned free of charge (without any new purchase obligation)
to retailers with a sales area of at least 400 m2, if they measure less than
25 cm. An efficient sorted waste collection for the environmentally friendly
disposal of the used device, or its subsequent recycling, helps avoid the
potential negative effects on the environment and people’s health, and
encourages the re-use and/or recycling of the construction materials.
Viale Vicenza, 14
36063 Marostica VI – Italy www.vimar.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>