VIMAR 20395 TORCIA Hand Lamp Instructions
- June 8, 2024
- VIMAR
Table of Contents
VIMAR 20395 TORCIA Hand Lamp
TORCIA, electronic hand lamp with high-efficiency LED, supply voltage 230 V~ 50-60 Hz, automatic emergency device, replaceable rechargeable Ni-MH battery, 2 hours of operating battery, grey – 2 modules.
TECHNICAL CHARACTERISTICS.
- Replaceable rechargeable Ni-MH battery with 4 elements 4.8 V 80 mAh.
- Battery charging time: 48 h for full charge.
- Operating time after charging: approx. 2 h.
- Photobiological risk: exempt.
- High-efficiency white LED and integral narrow angle lens; the direct current supply makes the LED always have the same brightness for the entire duration of the charge (approximately 2 hours).
- Slide switch to turn the TORCIA on and off when it is used as a hand lamp or to turn the auxiliary lighting function on and off (figure 1).
- Amber LED to indicate the auxiliary lighting function status (figure 1).
- Insertion and removal with “push-push” mechanism.
- Anti-removal lock with the screw provided: the screw must be positioned from the back of the charger socket and screwed fully in (figure 4).
- Installation in accordance with the wiring diagram shown in figure 5.
- Appliance of class II
OPERATION
The electronic TORCIA, inserted in the charger socket, also performs the function of auxiliary lighting in the event of a power failure.
Charging can take place as follows:
-
Charging with auxiliary lighting function turned off.
Switch in position “0” and amber LED off: with no mains power the TORCIA will remain switched off. -
Charging with auxiliary lighting function turned on.
Switch in position “I” and amber LED on: with no mains power the TORCIA will switch on and, when power comes back on, it will automatically switch off.
If the system is turned off for a long period, move the slide switch into
position “0” to prevent the TORCIA from discharging due to a lack of power.
The TORCIA is removed from the charger socket as follows:
- Lightly press the front of the device and then release immediately (figure 2).
- Remove the TORCIA by hand (fig. 3).
CHANGING THE BATTERY.
The TORCIA contains 1 Nickel-Metal Hydride (NiMH) element VIMAR 00910; proceed
as shown in figures 6, 7 and 8 to replace it, taking care not to reverse the
polarity of the con-nector (figure 8).
WARNING: Dispose of batteries in the specific differentiated collection bins.
INSTALLATION RULES.
The appliance must be installed in flush or surface mounting boxes with Eikon
mounting frames and cover plates.
Installation should be carried out by qualified personnel in compliance with
the current regulations regarding the installation of electrical equipment in
the country where the products are installed.
STANDARD COMPLIANCE.
- LV directive. EN 60598-1, EN 60598-2-2, EN 62471 standard.
- EMC directive. EN 61547, EN 61000-3-2, EN 61000-3-3, EN 55015 standard.
- REACH (EU) Regulation no. 1907/2006 – Art.33. The product may contain traces of lead.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>