ALLEGION 2821 Series Dummy Lever Instruction Manual

ALLEGION 2821 Series Dummy Lever

Installation Instructions

Step 1.

• Fold Template where indicated.

•  Position template on door edge at desired height.

• Firmly hold template & mark 5 hole centres (4 off 9mm & 1 off 25mm) at required backset.
  Note: 25mm hole 10mm deep only.

•  Drill Pilot holes – suggest 3mm, then enlarge (4 off) 9mm holes from both sides of door.

• Drill (1 off) 25mm hole 10mm deep on side of door dummy leverset will be fitted.

Step 2.
Install lever assemblies to door:

• Remove rosette cover (1a or 1b) from lever assembly.

• Place dummy lever assembly (2) with latch alignment posts (3) against door face.

•  Place dummy plate (4) into position, on back of door.

• Fasten lever assembly & dummy plate together with screws (5) & tube nuts (6) provided: Use long screws for thick doors and short screws for thin doors.

• Install screws (5) from dummy plate side into the vertical tube nut holes (8) of the dummy leverset under-rose. Then tighten both screw heads.
  2921

• Reapply rosette cover (1a) to under-rose by pushing the cover over the rubber rring until flush with door.
  2821

• Reapply rosette cover (1b) to under-rose by pushing the cover over the rubber ring until flush with door. The *grub-screw, which is already located in the rosette cover, should be on the lower face.

• Check the rosette cover is square with the door edge. Fasten in place with *grub-screw using allen key (9) provided.

Note: Grub-screw is already located in the rosette cover.

Dimension

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>