ALLEGION XE360 Falcon 25 RX Wiring Kit Installation Guide

RX Wiring Kit
XE360 Falcon 25 Exit
Installation Instructions

XE360 Falcon 25 RX Wiring Kit

https://alle.co/XE360-qr

Scan for user guide, interactive instructions, warranty and more! alle.co/XE360

1. Route wires and install cable mounts.
   1a Slide the two included cable mounts onto the Common and Normally Open wires from the exit device RX switch.
   1b Use the included swabs to remove any grease from the mechanism case.
   1c Position and route wires into mechanism as shown.
   1d Expose adhesive and stick mounts into place.

2. Route wires through center case and make connections.
   2a Route wires into center case as shown. Shorten wires as necessary.
   2b Connect to XE360 harness using the provided Scotchlok connectors (color orientation does NOT matter).

© Allegion 2024
115865 Rev. 01/24-a

References

• Allegion

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>