SmallRig ST17H66 Integrated Power Supply User Manual
- June 8, 2024
- SmallRig
Table of Contents
SmallRig ST17H66 Integrated Power Supply
Product details
- This product is powered by button battery (2.0V-3.3V)
- The button battery provides 2.0-3.3 volts to the ST17H66.
- ST17H66 integrated power supply control and adjustment.
- Use the button to turn on/off the device while green LED Will blink.
- When the device is connected to the smartphone, press the button to take a picture
- Phone (iOS and Android). Button command using bluetooth HID
- The keyboard keycode is sent to the phone (iOS or Android).
- The phone may be Take photos when a special HID key is input from a Bluetooth device.
- The green indicator shows the operating status and battery status.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>