i safe MOBILE IS530.1 Android 4G Smartphone User Manual

i safe MOBILE IS530.1 Android 4G Smartphone

KEYS AND SPECIAL FEATURES

Document No 1029MM01REV02
Version: 2020-03-13
(c) 2020 i.safe MOBILE GmbH
i safe MOBILE GmbH
i_Park Tauberfranken 10
97922 Lauda-Koenigshofen
Germany
Tel +49 9343/60148-0
info@isafe-mobile.com
www.isafe-mobile.com

INTRODUCTION

This document contains information and safety regulations which are to be observed without fail for safe operation of the device IS530.1 under the described conditions. Non-observance of this information and instructions can have serious consequences and / or may violate regulations.
Please read the manual and these safety instructions before using the device. In case of any doubt, the German version shall apply.
The current EU-declaration of conformity, certificates, safety instructions and manuals can be found at www.isafe-mobile.com or requested from i.safe MOBILE GmbH.

RESERVATION

The content of this document is presented as it currently exists. i.safe MOBILE GmbH does not provide any explicit or tacit guarantee for the accuracy or completeness of the content of this document, including, but not restricted to, the tacit guarantee of market suitability or fit-ness for a specific purpose unless applicable laws or court decisions make liability mandatory. i.safe MOBILE GmbH reserves the right to make changes to this document or to withdraw it any time without prior notice. Changes, errors and misprints may not be used as a basis for any claim for damages. All rights reserved.
i.safe MOBILE GmbH cannot be held responsible for any data or other loss and direct or indirect damages caused by any improper use of this device.

EX-SPECIFICATIONS

The device IS530.1 is suitable for use in potentially explosive atmospheres classified zone 1/21 and 2/22 in accordance with directives 2014/34/EU and 2014/53/EU, as well as the IECEx scheme

EX-MARKINGS

• ATEX:
  II 2G Ex ib IIC T4 Gb
  II 2D Ex ib IIIC T135°C Db IP6X
  EU Type Examination Certificate: EPS 19 ATEX 1 037 X
  CE-designation: 2004

• IECEx:
  Ex ib IIC T4 Gb
  Ex ib IIIC T135°C Db IP6X
  IECEx Certificate: IECEx EPS 19.0014X

• North America:
  Class I Div 1 Groups A, B, C, D, T4 Class II Div 1 Groups E, F, G , T135˚C Class III Div 1
  CSA19CA70220251

• Temperature range:
  -20°C … +60°C

• Manufactured by:
  i.safe MOBILE GmbH
  i_Park Tauberfranken 10
  97922 Lauda-Koenigshofen Germany

EU-DECLARATION OF CONFORMITY

The EU-declaration of conformity can be found at the end of this manual

FAULTS AND DAMAGES

If there is any reason to suspect that the safety of the device has been compromised, it must be withdrawn from use and removed from any ex-hazardous areas immediately. Measures must be taken to prevent any accidental restarting of the device. The safety of the device may be compromised, if, for example:

• Malfunctions occur.
• The housing of the device shows damage.
• The device has been subjected to excessive loads
• The device has been stored improperly.
• Markings or labels on the device are illegible.

We recommend that a device displaying errors or in which an error is suspected be sent back to i.safe MOBILE GmbH to be checked.

EX-RELEVANT SAFETY REGULATIONS

Use of this device assumes that the operator observes the conventional safety regulations and has read and understood manual, safety instructions and certificate.
The following safety regulations must also be complied with:

• Inside ex-hazardous areas the covers of all interfaces must be closed.
• To ensure the IP-protection, it has to be ensured that all gaskets are present and functional. There must be no large gap between the two halves of the housing.
• The device may only be charged outside ex-hazardous areas using the i.safe PROTECTOR 2.0 or i.safe PROTECTOR 3.0 USB-cable or other equipment approved by i.safe MOBILE GmbH. When using the IS-HS1.1 headset, the headset must be securely fastened to the ISM interface. Physical connections to equipment other than the IS-HS1.1 headset are only allowed outside ex-hazardous areas using the i.safe PROTECTOR 2.0 and i.safe PROTECTOR 3.0 USB-cable or other equipment approved by i.safe MOBILE GmbH.
• The device may only be charged at ambient temperatures between +5°C … +35°C.
• The device may not be exposed to any aggressive acids or alkalis.
• The device may only be used in zones 1, 2, 21, or 22.
• Only accessories approved by i.safe MOBILE GmbH may be used.

EX-RELEVANT SAFETY REGULATIONS FOR NORTH AMERICA

• Conditions of Acceptability:

• The battery shall only be charged outside the explosion hazardous areas only and using a suitably certified Class 2 power supply with the following output parameters:
  V = 5VDC I = 2000mA

• The smartphone must be protected against excessive UV light emission and high electrostatic processes.
  The USB interface (type C) located at the bottom side is for data transmission and it is used in non hazardous areas. It is not permitted to open the USB interface cover in hazardous locations.

• The ISM interface of the IS530.1 located at the right side can be used within hazardous areas with approved headsets, Remote Speaker Microphones(RSM) and add-ons.

• For the ISM interface connection the intrinsically safe approved accessories must comply with entity parameters according to document 1029AD04 i.e. Headset IS-HS1.1 is approved to be used on ISM interface. If the ISM interface is not used, it must be securely closed by the cover provided for this purpose.

FURTHER SAFETY ADVISES

• Do not touch the screen of the device with sharp objects. Dust particles and nails may scratch the screen. Please maintain the screen clean. Remove dust on the screen with a soft cloth gently, and do not scratch the screen.
• Do not put the device in environments with excessive temperatures, as this could lead to heating of the battery, resulting in fi re or explosion.
• Do not charge the device near any fl ammable or explosive substances.
• Charge the device under indoor conditions only.
• Do not charge the device in environments with much dust or humidity.
• Do not use the device in areas where regulations or legislatives prohibit the use.
• Do not expose the device or charger to strong magnetic fi elds, such as are emitted from induction ovens or microwaves.
• Do not attempt to open or repair the device. Improper repair or opening can lead to the destruction of the device, fi re or explosion. Only authorized personnel are allowed to repair the device.
• Power off the device in hospitals or other places where the use of mobile phones is prohibited This device may aff ect proper work of medical equipment, such as pacemakers. Always keep a distance of at least 15 cm between the device and these devices.
• Observe all corresponding laws that are in force in the respective countries regarding the use of devices while operating a vehicle.
• Please power off the device and disconnect the charging cable before cleaning the device.
• Do not use any chemical cleaning agents to clean the device or the charger. Use a damp and anti-static soft cloth for cleaning.
• Do not discard old and abandoned lithium batteries into the trash, send them to designated waste disposal locations.
• The user alone is responsible for any and all damages and liabilities caused by malware downloaded when using the network or other data-exchange functions of the device. i.safe MOBILE GmbH cannot be held responsible for any of those claims.

WARNING
i.safe MOBILE GmbH will not assume any liability for damages caused by disregarding any of these advices or by any inappropriate use of the device.

MAINTENANCE/REPAIR

Please note any legal requirements for periodic inspection The device itself has no user-serviceable parts. It is recommended to perform inspections according to the safety regulations and advises. If there is a problem with the device, please contact your vendor or consult the service center. If your device is in need of repair, you can either contact the service center or your vendor.

BATTERY

The device may only be charged at ambient temperatures in a range from +5°C … +35°C

INSTALLATION OF THE MICRO SIM CARD

The device features two micro SIM card slots. These are located in the battery compartment under the battery. Power off the device before installation. If you have installed two micro SIM cards, you can choose your primary card in