SAMSUNG QA43LS05B 43 Inch The Sero QLED 4K TV User Manual

: June 8, 2024
: Samsung

Table of Contents

SAMSUNG QA43LS05B 43 Inch The Sero QLED 4K TV
Contact SAMSUNG WORLD WIDE
Power
Installation
Providing proper ventilation for your TV
Safety Precaution
Operation
Caring for the TV
What’s in the Box?
Initial Setup
Troubleshooting and Maintenance
Specifications
Decreasing power consumption
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

SAMSUNG QA43LS05B 43 Inch The Sero QLED 4K TV

Contact SAMSUNG WORLD WIDE

If you have any questions or comments relating to Samsung products, please contact the Samsung service centre.

Country	Samsung Service Centre	Web Site
SINGAPORE	1800 7267864	1800-SAMSUNG

+603-7713 7420 (Overseas contact)

| www.samsung.com/my/support

PHILIPPINES

| 1-800-10-726-7864 [ PLDT Toll Free ]

1-800-8-726-7864 [ Globe Landline and Mobile ] 02-8-422-2111 [ Standard Landline ]

|

www.samsung.com/ph/support

INDIA| 1800 40 SAMSUNG (1800 40 7267864) (Toll-Free)

1800 5 SAMSUNG (1800 5 7267864) (Toll-Free)

|

www.samsung.com/in/support

NEPAL| 16600172667 (Toll Free for NTC Only)

9801572667 (Toll Free for Ncell users)

BANGLADESH| 08000-300-300 (Toll free)

09612-300-300

Please read the Safety Instructions before using your TV. Refer to the table below for an explanation of symbols which may be on your Samsung product.

CAUTION

RISK OF ELECTRIC SHOCK. DO NOT OPEN.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). THERE ARE

NO USER SERVICEABLE PARTS INSIDE. REFER ALL SERVICING TO QUALIFIED PERSONNEL.

| This symbol indicates that high voltage is present inside. It is dangerous to make any kind of contact with any internal part of this product.
| This symbol indicates that this product has included important literature concerning operation and maintenance.
| Class II product: This symbol indicates that a safety connection to electrical earth (ground) is not required. If this symbol

is not present on a product with a mains lead, the product MUST have a reliable connection to protective earth (ground).

| AC voltage: Rated voltage marked with this symbol is AC voltage.
| DC voltage: Rated voltage marked with this symbol is DC voltage.
| Caution. Consult instructions for use: This symbol instructs the user to consult the user manual for further safety related information.

Power

Do not overload wall outlets, extension cords, or adaptors beyond their voltage and capacity. It may cause fire or electric shock.
Refer to the power specifications section of the manual and/or the power supply label on the product for voltage and amperage information.
Power-supply cords should be placed so that they are not likely to be walked on or pinched by items placed upon or against them. Pay particular attention to cords at the plug end, at wall outlets, and at the point where they exit from the appliance.
Never insert anything metallic into the open parts of this apparatus. This may cause electric shock.
To avoid electric shock, never touch the inside of this apparatus. Only a qualified technician should open this apparatus.
Be sure to plug in the power cable until it is firmly seated. When unplugging the power cable from a wall outlet, always pull on the power cable’s plug. Never unplug it by pulling on the power cable. Do not touch the power cable with wet hands.
If this apparatus does not operate normally – in particular, if there are any unusual sounds or smells coming from it – unplug it immediately and contact an authorised dealer or Samsung service centre.
To protect this apparatus from a lightning storm, or to leave it unattended and unused for a long time, be sure to unplug it from the wall outlet and disconnect the antenna or cable system.
- Accumulated dust can cause an electric shock, an electric leakage, or a fire by causing the power cable to generate sparks and heat or by causing the insulation to deteriorate.
Use only a properly grounded plug and wall outlet.
- An improper ground may cause electric shock or equipment damage. (Class l Equipment only.)
To turn off this apparatus completely, disconnect it from the wall outlet. To ensure you can unplug this apparatus quickly if necessary, make sure that the wall outlet and power plug are readily accessible.

Installation

Do not place this apparatus near or over a radiator or heat register, or where it is exposed to direct sunlight.
Do not place vessels (vases etc.) containing water on this apparatus, as this can result in a fire or electric shock.
Do not expose this apparatus to rain or moisture.
Be sure to contact an authorised Samsung service centre for information if you intend to install your TV in a location with heavy dust, high or low temperatures, high humidity, chemical substances, or where it will operate 24 hours a day such as in an airport, a train station, etc. Failure to do so may lead to serious damage to your TV.
Do not expose this apparatus to dripping or splashing.

Providing proper ventilation for your TV

Leave a space around the product for ventilation. Failing to maintain proper ventilation may result in a fire or a problem with the product caused by an increase in its internal temperature.
For installation, be sure to secure the spaces as shown in the figure.

When you install your TV with a stand, we strongly recommend you use parts provided by Samsung Electronics only. Using parts provided by another manufacturer may cause difficulties with the product or result in injury caused by the product falling.

SAMSUNG QA43LS05B 43 Inch The Sero QLED 4K TV 1

Safety Precaution

Using the stand provided with the product, install The Sero on a flat surface.

Caution: Pulling, pushing, or climbing on the TV may cause the TV to fall. In particular, ensure your children do not hang on or destabilise the TV. This action may cause the TV to tip over, causing serious injuries or death. Follow all safety precautions provided in the Safety Flyer included with your TV.

WARNING: Never place a television set in an unstable location. The television set may fall, causing serious personal injury or death. Many injuries, particularly to children, can be avoided by taking simple precautions such as:

Always use cabinets or stands or mounting methods recommended by Samsung.
Always use furniture that can safely support the television set.
Always ensure the television set is not overhanging the edge of the supporting furniture.
Always educate children about the dangers of climbing on furniture to reach the television set or its controls.
Always route cords and cables connected to your television so they cannot be tripped over, pulled or grabbed.
Never place a television set in an unstable location.
Never place the television set on tall furniture (for example, cupboards or bookcases) without anchoring both the furniture and the television set to a suitable support.
Never place the television set on cloth or other materials that may be located between the television set and supporting furniture.
Never place items that might tempt children to climb, such as toys and remote controls, on the top of the television or furniture on which the television is placed.

If the existing television set is going to be retained and relocated, the same considerations as above should be applied.

When you have to relocate or lift the TV for replacement or cleaning, be sure not to pull out the stand.

Precautions for moving The Sero
Lift the product by two persons upright only in portrait mode.

Never move the product in landscape mode.
If the product falls, it may cause injury or product damage. Be careful not to hurt hands or feet.
Be careful not to hold the screen display while lifting the product
Do not lift the product by yourself.
Never move the product by dragging it.
Never hold the display for moving.

Operation

This apparatus uses batteries. In your community, there might be environmental regulations that require you to dispose of these batteries properly. Please contact your local authorities for disposal or recycling information.
Store the accessories (remote control, or etc.) in a location safely out of the reach of children.
Do not drop or strike the product. If the product is damaged, disconnect the power cable and contact a Samsung service centre.
Do not dispose of remote control or batteries in a fire.
Do not short-circuit, disassemble, or overheat the batteries.
CAUTION: There is danger of an explosion if you replace the batteries used in the remote with the wrong type of battery. Replace only with the same or equivalent type.
WARNING – TO PREVENT THE SPREAD OF FIRE, KEEP CANDLES AND OTHER ITEMS WITH OPEN FLAMES AWAY FROM THIS PRODUCT AT ALL TIMES.

Caring for the TV

To clean this apparatus, unplug the power cable from the wall outlet and wipe the product with a soft, dry cloth. Do not use any chemicals such as wax, benzene, alcohol, thinners, insecticide, aerial fresheners, lubricants, or detergents. These chemicals can damage the appearance of the TV or erase the printing on the product.
The exterior and screen of the TV can get scratched during cleaning. Be sure to wipe the exterior and screen carefully using a soft cloth to prevent scratches.
Do not spray water or any liquid directly onto the TV. Any liquid that goes into the product may cause a failure, fire, or electric shock.

What’s in the Box?

Make sure the following items are included with your TV. If any items are missing, contact your dealer.

Samsung Smart Remote
User Manual
Warranty Card / Regulatory Guide (Not available in some locations)
TV Power Cable
The items’ colours and shapes may vary depending on the models.
Cables not included can be purchased separately.
Check for any accessories hidden behind or in the packing materials when opening the box.

Initial Setup

When you turn on your TV for the first time, it immediately starts the Initial Setup. Follow the instructions displayed on the screen and configure the TV’s basic settings to suit your viewing environment. You can connect The Sero via the SmartThings app on your mobile device to control the Portrait Mode and the related functions on the TV.

Using the TV Controller
Using the TV Controller button at the top on the rear panel, you can turn on The Sero. If the button is pressed again with the power on, you can see the function menus on the screen. The usage of the menus is shown in the following figure.

Remove the protective film attached on the SAMSUNG logo. The reception sensitivity may decrease when the sensor is blocked.

SAMSUNG QA43LS05B 43 Inch The Sero QLED 4K TV 2

Setting the sound sensor
You can turn on or off the sound sensor by using its button at the bottom of the TV. With the TV on, you can push the button backward to turn on the sound sensor or forward to turn off it. See the pop-up window on the TV to check whether the sound sensor is turned on or off.

The position and shape of the sound sensor may differ depending on the model.
During analysis using data from the sound sensor, the data is not saved.

Troubleshooting and Maintenance

Troubleshooting
For more information, refer to “Troubleshooting” or “FAQ” in the e-Manual. > Menu > Settings > Support > Open e-Manual > Troubleshooting or FAQ If none of the troubleshooting tips apply, please visit “www. samsung.com” and click Support or contact the Samsung service centre.

This TFT LED panel is made up of sub pixels which require sophisticated technology to produce. There may be, however, a few bright or dark pixels on the screen. These pixels will have no impact on the performance of the product.
To keep your TV in optimum condition, upgrade to the latest software. Use the Update Now or Auto update Support > Software Update > Update Now or Auto update).
In Portrait Mode, some apps or external inputs may not support the full screen.

The TV won’t turn on.

Make sure that the power cable is securely plugged in to the TV and the wall outlet.
Make sure that the wall outlet is working and the remote control sensor at the bottom of the TV is lit and glowing a solid red.
Try pressing the TV Controller button behind the screen to make sure that the problem is not with the remote control. If the TV turns on, refer to “The remote control does not work”.

The remote control does not work.

Check if the remote control sensor at the bottom of the TV blinks when you press the button on the remote control.
- When the remote’s battery is discharged, charge the battery using the USB charging port (C-type), or turn over the remote to expose the solar cell to light.
Try pointing the remote directly at the TV from 1.5-1.8 m away.
If your TV came with a Samsung Smart Remote (Bluetooth Remote), make sure to pair the remote to the TV. To pair a Samsung Smart Remote, press the and buttons together for 3 seconds.

Eco Sensor and screen brightness
Eco Sensor adjusts the brightness of the TV automatically. This feature measures the light in your room and optimises the brightness of the TV automatically to reduce power Settings > All Settings > General & Privacy > Power and Energy Saving > Brightness Optimisation.

The eco sensor is located at the bottom of the TV. Do not block the sensor with any object. This can decrease picture brightness.

Specifications

Display Resolution: 3840 x 2160
Model Name: QA43LS05B
(Singapore only: QA43LS05BAK)
Sound (Output): 60 W
Operating Temperature: 50 °F to 104 °F (10 °C to 40 °C)
Operating Humidity: 10 % to 80 %, non-condensing
Storage Temperature: -4 °F to 113 °F (-20 °C to 45 °C)
Storage Humidity: 5 % to 95 %, non-condensing

Notes

This device is a Class B digital apparatus.
For information about the power supply, and more information about power consumption, refer to the information on the label attached to the product.
On most models, the label is attached to the back of the TV. (On some models, the label is inside the cover terminal.)
The images and specifications of the Quick Setup Guide may differ from the actual product.

Decreasing power consumption

When you shut the TV off, it enters Standby mode. In Standby mode, it continues to draw a small amount of power. To decrease power consumption, unplug the power cable when you don’t intend to use the TV for a long time.

Licences

The terms HDMI and HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc. in the United States and other countries.