smartwares CIP-33900AT Outdoor Light with Camera Instruction Manual

Table of Contents

NON-REPLACEABLE LIGHT SOURCE

Technical data:
Wireless technology: Wi-Fi
Frequency: 2.4 GHz
Max. Radio Transmission Power: 15,59dBm
Antenna gain: 3dB

LSC-App

Information for power adapter:
Input: 100-240V 50/60Hz
Output: DC 5.0V 2.5A
– 900 Lumen
– 7000 Kelvin
– IP65

Only use supplied power adaptor

Optional: Insert a MicroSD card (not included)

First make sure your camera is not powered. Insert your Micro-SD card in the MicroSD card slot on the camera. Only use a Class 10 MicroSD card (max 128GB).
Choose a location to place your camera and check if there is a strong Wi-fi signal.
Tip: Complete set up on the LSC Smart Connect app first before mounting the camera to the wall. See the section “Download the LSC Smart Connect app” in this manual.
Mark the drill holes using the backplate. Also, mark a drill hole of at least 15mm (in diameter) to lead the camera cable inside.
Note: Before drilling, make sure that there are no wires or pipes located in the wall to prevent damage.
Drill the holes and mount the backplate to the wall using the screws and plugs supplied.
Connect the USB cable the camera and the other side to the power adapter.
Place the power adapter in a wall socket.
Note: Use only the power adaptor provided.

Note: This item only works on a 2.4GHz Wi-Fi network, not on a 5GHz Wi-Fi network.
One device can only be paired with one App account at a time, if the device has already been paired with another account, then it can’t be paired to a new account.
The device can be removed from the app account by deleting it from the app.

Download the LSC Smart Connect App from the Appstore or Google Playstore or scan the QR code.
Open the LSC Smart Connect App, click “+” or “Add Device”. Then select “Security” on the “Select Device Type” page.
Select “Smart Lighting Camera”. Power the device on and make sure the a prompt tone is heard.
Input the Wi-Fi password and click on “Confirm”. Hold the device about 20 cm from the camera lens and scan the QR Code with the device.
When the device sounds “dong dong dong”, click on “I heard the beep” in the app. You can then complete the set-up. (About +/- 30 s.)

Smart mode: If you want the light to go on automatically when motion is detected, select: “Smart mode”. The light will go off 1 minute after motion is detected. The Smart mode will only work when it is dark and when the feature ‘Motion detection’ is activated.
Infrared mode: With this mode you can see the camera images at night, without the white light.
Color light mode:
The light will constantly be on when it is dark.

Press and hold the reset button for 5 seconds to reset the camera. (If you have modified the settings, they will return to factory defaults)
One device can only be paired with one App account at a time, if the device has already been paired with another account, then it can’t be paired to a new account.
The device can be removed from the app account by deleting it from the app.