PASSTECH ER200 RFID Reader User Manual
- June 8, 2024
- Passtech
Table of Contents
PASSTECH ER200 RFID Reader
Characteristics
-
SMARTPHONE App
Access through Smartphone Application by BLE communication with ER200. -
RFID READER
Access through RFID CARD. -
RS232C
Data communication between RS232C and accessories.
ER200 Parts names
Setting ER200 Reader
How to set Reader -Embedded type
-
Select a Device
Select a Hotel -
Select the Setting
-
Enter required information Device ID = XXXX (4 digit number) Sub Company ID = KEY VENDOR ID (TEST default = 001001)
ALL Floor = Select Enable / Disable Floor Total = Enter the whole floor number
Start Floor = Enter the start floor number
End Floor = Enter the last floor number
Common Floor = Select the common floor
How to use Reader -Embedded type
- Check if the cards (guest card / maintenance card / maid card) that were issued from the client program are working on the reader.
- Check if the smartphone APP works on the reader by BLE communication.
How to use ER200
How to use Reader -Embedded type
- LED and sound when using available RF card
- LED and sound when using expired RF card
- LED and sound when using not available card
ER200 Specification
| Item | RFID / Reader |
|---|---|
| CPU | 32-bit ARM® Cortex™-M4 |
| User Credential | RFID card / QR code / App (BLE) |
| RFID Protocol | ISO 14443A / MIFARE / DESFIRE |
| Security | AES 128 |
| FW Update | BLE |
| LED | RGB indicator |
| Wire communication | RS232C |
| Material (Color) | Acrylic |
(Black, White, Transparent, Translucent, etc)
Size| 15 X 7 cm
Certificate| KC
Power| DC12V 1.5A (Adapter – optional)
RTC Backup battery| CR2032 1ea
Indicator| Buzzer, LED
Operating Temperature| 0 ~ 50ºC
Regulatory Statement
The revised User Manual does not contain the FCC required warning statements.
- a. Rule Part 15.19(a)(3): This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
- Rule Part 15.21: The users manual or instruction manual for an intentional or unintentional radiator shall caution the user that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Responsible Party –
Cardcom
Address: 1301 S. Beach Blvd. Ste-P La Habra, CA 90631
Tel.: 562-943-6300
E-mail: passtech@esmartlock.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>