PROCHEM S112 Ultra-Clean Clear Rinse User Manual
- June 9, 2024
- PROCHEM
Table of Contents
ALL FIBER RINSE
Ultra-Clean Clear Rinse
with Residue Release Technology
FOR PROFESSIONAL USE ONLY
S112 Ultra-Clean Clear Rinse
All Fiber Rinse • WARNING Causes serious eye irritation. May cause
respiratory irritation.
Prevention: Wash face, hands and any exposed skin thoroughly after
handling. Wear protective gloves/protective clothing/eye protection/face
protection. Avoid breathing
dust/fume/gas/mist/vapors/spray. Use only outdoors or in a well-ventilated
area.
Response: IF IN EYES: Rinse cautiously with water for several
minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
If eye irritation persists: Get medical advice/attention.
IF INHALED: Remove person to fresh air and keep comfortable for
breathing. If any condition(s) persist: Get medical advice/attention. More
detailed First Aid measures may be found in Section 4 of the SDS.
Storage: Store locked up.
Disposal: Dispose of contents in accordance with local/regional/
national/international regulations. 0.1% of the mixture consists of
ingredient(s) of unknown acute toxicity
Contains: sodium tripolyphosphate (CAS 7758-29-4); citric acid (CAS
77-92-9); ethoxylated alcohols, C9-C11 (CAS 68439-46-3); phosphate ester (CAS
68130-47-2); tetrasodium pyrophosphate (CAS 7722-88-5); Fragrance blend;
alcohols, C10-14, ethoxylated; phosphoric acid, disodium salt READ SDS at
LegendBrands.com
READ ALL INSTRUCTIONS AND PRECAUTIONS BEFORE USING INSTRUCTIONS
For carpet and water-cleanable upholstery. Pre-test in an inconspicuous
location. Do not mix with any other products.
TRUCKMOUNT USE: Mix 3 cups (750 cc) into 5 gallons (18.93L) of warm water
ntil completely dissolved to make truckmount concentrate. Set truckmount
chemical injection system for 3 to 8 gallons (11.36 – 30.28L) per hour,
depending on soil conditions.
PORTABLE USE: Mix 1 to 2 oz. (30 – 60 cc) per 5 gallons (18.93L) of hot
water for routine cleaning. Mix 2 to 4 oz. (60 – 120 cc) per 5 gallons
(18.93L) for heavy soil.
POSTSPRAY: Mix 1-2 oz. (30 – 60 cc) per gallon (3.79L). Apply 1 gallon
(3.79L) RTU per 200 – 500 square feet (depending on pile density) after
extraction with another product. Rake into carpet for maximum performance. pH:
4.2 – 4.5 ready to use
CAUTION: Use product only in well-ventilated area. To avoid skin
irritation or slip hazards, do not walk on wet carpets with bare feet.
NOTICE: Product must be stored at room temperature (59°F – 86°F/ 15°C –
30°C). Keep in sealed container when not in use. Product is not warranted if
used for repack, improperly stored, or used in a manner not consistent with
manufacturer’s instructions.
Made in U.S.A
INFOTRAC:
1-800-535-5053
(North America)
NOTICE: Seller’s and manufacturer’s liability for any losses or damages resulting from any cause shall not exceed the purchase price of this product. User shall determine the suitability of the product for intended use, and user assumes all risk and liability. The manufacturer and seller make no representation or warranty, including merchantability or any other kind, express or implied.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>