BATAVIA FIXXPACK 12V Battery 2 Ah Instruction Manual

: June 9, 2024
: BATAVIA

Table of Contents

BATAVIA FIXXPACK 12V Battery 2 Ah
OVERVIEW
DEAR CUSTOMERS
ADDITIONAL SAFETY INSTRUCTIONS FOR BATTERIES AND CHARGERS
OPERATION
Removing the battery from the machine
TECHNICAL DATA
DISPOSAL
Documents / Resources

BATAVIA FIXXPACK 12V Battery 2 Ah

OVERVIEW

BATAVIA FIXXPACK 12V Battery 2 Ah 1

Battery
Battery release button
Charger
Green LED
Red LED

DEAR CUSTOMERS

Instruction manuals provide valuable hints for using your new device. They enable you to use all functions, and they help you avoid misunderstand-ings and prevent damage. Please take the time to read this manual carefully and keep it for future reference.

ADDITIONAL SAFETY INSTRUCTIONS FOR BATTERIES AND CHARGERS

Please note the included General Safety Notes and the following safety notes to avoid malfunctions, damage or physical injury:
Batteries
WARNING: Improper battery use may result in a fire, explosion, or other hazard.
WARNING: The battery fluid may cause personal injury or damage to property. In case of skin con-tact, immediately rinse with water. If redness, pain or irritation occurs seek medical attention. In case of eye contact, rinse immediately with clean water and seek medical attention.

Never attempt to open for any reason.
Do not expose the battery to water.
Do not expose the battery to heat.
Do not store in locations where the tempera-ture may exceed 40 °C.
Keep batteries away from children.
Charge only at ambient temperatures between 10 °C and 40 °C.
Charge only using the charger provided with the appliance/tool.
Use power tools only with specifically desig-nated battery packs. Use of any other battery packs may create a risk of injury and fire.
When disposing of batteries, follow the instructions given in the section “Disposal”.
Do not damage/deform the battery pack either by puncture or impact, as this may create a risk of injury and fire.
Do not charge damaged batteries.
Take special care of the battery. Avoid drop-ping it onto any hard surface and do not sub-ject it to pressure or any other form of mechanical stress. Keep the battery away from extreme heat and cold.
Important Danger! Never short-circuit the battery or expose it to moisture. Do not store it together with any metal parts which could short-circuit the contacts. The battery could overheat, start burning or explode.
Under extreme conditions, battery leakage may occur. When you notice liquid on the batteries, proceed as follows: Carefully wipe the liquid off using a cloth. Avoid skin contact. In case of skin or eye contact, follow the instructions below.

Chargers

Your charger has been designed for a specific voltage. Always check that the mains voltage cor-responds to the voltage on the rating plate.
WARNING:

When not in use and before cleaning and servicing, disconnect the battery charger from the power supply.
Never attempt to replace the charger unit with a regular mains plug.
Use your charger only to charge the battery in the appliance/tool with which it was supplied. Other batteries could burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.
If the supply cord is damaged, it must be replaced by the manufacturer or an authorized Service Centre in order to avoid a hazard.
Do not expose the charger to water.
Do not open the charger.
Do not probe the charger.
The appliance/tool/battery must be placed in a well ventilated area when charging.
The charger is intended for indoor use only.

OPERATION

Operation of Lithium-Ion Batteries
Lithium-ion batteries share many characteristics with conventional batteries. The major difference is that Lithium-ion batteries do not have a “memory” and do not require to be completely discharged periodically. It is recommended to charge Lithi-um-ion batteries after each use so they will be fully charged when needed. Lithium-ion batteries perform best and deliver peak output power at room temperature. When operated in lower temperatures, the battery output will be reduced.
Note: A fully charged battery will loose about 2% of its charge per month during storage.
Before use
The battery must be charged before using it for the first time.

Removing the battery from the machine

Push the battery release button (2) and pull the battery (1) out of the machine.

WARNING: Do not try to remove the battery with-out pressing the battery release button. The drill or battery could be damaged.
Inserting the battery into the machine
Ensure that the exterior of the battery is clean and dry before connecting to the charger or machine.

Insert the battery (1) into the machine, push the battery further forward until it clicks into place.

Note: Make sure the battery and machine are lined up correctly. If the battery does not slide onto the machine easily, don’t force it. Instead, remove the battery; check the top of battery and the machine slot are clean and undamaged and that the contacts are not bent.
Charging the Battery
WARNING: Failure to follow the correct procedure when charging batteries will result in permanent damage.

Plug the charger plug into an electrical outlet. The green LED indicator (4) on the charger (3) will lighten up.
Slide a battery (1) onto the battery charger (3).
Once charging commences, the red LED (5) will illuminate.
When the battery is fully charged, the green LED (4) will illuminate.

Note: Make sure the battery and battery charger are lined up correctly. If the Battery does not slide onto the battery charger easily, don’t force it. Instead, remove the battery; check the top of battery and the battery charger slot are clean and undamaged and that the contacts are not bent.
IMPORTANT: When a low charge level is indi-cated be aware the tool may stop operating while using the tool. In some instances this may be dangerous. It is recommended to always ensure the battery pack has a good charge level.
Notes about Battery Charging

Let a hot battery cool down before charging it.
The battery should be charged at ambient temperatures between 10 °C and 40 °C (ide-ally around 20 °C).
After charging, allow 15 minutes for the bat-tery to cool before use.
Ensure that the charger is disconnected from the mains supply after use, and is stored correctly.
Do not leave batteries on charge for extended periods and never store batteries on charge.
The battery charger monitors battery temper-ature and voltage while charging. Remove the battery once charging has been completed to maximise charge cycles of the battery and not waste power.
Do not store Lithium-Ion battery packs in a discharged state long term. This can damage the Lithium-Ion cells. For long-term storage, store batteries in a high charge state discon-nected from the power tool.
The capacity of batteries will reduce over time. After 100 charge cycles, the battery’s opera-tion time and the maximum torque perfor-mance of the tool will slightly reduce. This decline will continue until the battery has mini-mal capacity after 500 charge cycles. This is normal and not a fault with the battery pack.

TECHNICAL DATA

7064221 Li-Ion 2.0 Ah
Rated voltage: 12 V
Weight: 0.19 kg

DISPOSAL

Disposing of packaging

Dispose of packaging according to type. Sort the paperboard and cardboard as waste paper and the film as recyclable material.

Disposing of batteries

Batteries and rechargeable batteries must not go in domestic waste!

As a consumer you are legally obliged to dispose of all batteries, irrespective of whether they contain harmful substances* or not, at a collection point in your community/district or at a retail outlet, so that they can be disposed of in an environmentally friendly manner. Marked with: Cd = Cadmium, Hg = Mercury, Pb = Lead, Li = Lithium.
EC-DECLARATION OF CONFORMITY

We, the Batavia B.V., Weth. Wassebaliestraat 6d, NL-7951 SN Staphorst, declare by our own responsibility that the Item-No 7064221 is accord-ing to the basic requirements. For the evaluation of conformity, the following harmonized standards were consulted:

EN 62841-1:2015
EN 62133-2:2017
Staphorst, 01 March 2022

UK DECLARATION OF CONFORMITY

We, the Batavia B.V., Weth. Wassebaliestraat 6d, NL-7951 SN Staphorst, declare by our own responsibility that the Item-No 7064221 is accord-ing to the basic requirements, which are defined in the UK Regulations Supply of Machinery (Safety) Regulations 2008, Electromagnetic Compatibility Regulations 2016, Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment Regula-tions 2012 and their amendments. Staphorst, 01 March 2022 Meino Seinen, QA Representative Batavia B.V., Weth. Wassebaliestraat 6d, 7951 SN Staphorst, Netherlands

The product and the user manual may be subject to changes. Technical data may be changed with-out prior notice.

Documents / Resources

| BATAVIA FIXXPACK 12V Battery 2 Ah [pdf] Instruction Manual
FIXXPACK 12V Battery 2 Ah, FIXXPACK 12V Battery, Battery, 12V Battery 2 Ah, 12V Battery, 7064221, BT-CLB007
---|---