Lenco LED-2423BK 24 Inch LED Television with 12V Car Adapter User Guide

: June 9, 2024
: Lenco

Table of Contents

LED-2423BK 24 Inch LED Television with 12V Car Adapter
Read User Manual Online (PDF format)
Download This Manual (PDF format)

LED-2423BK 24 Inch LED Television with 12V Car Adapter
User Guide

LED-2423BK 24 Inch LED Television with 12V Car Adapter

Insert the batteries into the Remote Control
Remove the back cover to reveal the battery compartment. Insert two size AAA batteries. Make sure the (+) and (-) signs match (observe correct polarity). Place the cover back on.
Connect the antenna to your TV
Connect the TV to the mains socket
To switch the TV on
Connect the power cord to the mains socket. Then the standby LED lights up. To switch on the TV from standby mode either;
Press the Standby button, a numeric button or Programme +/- button on the remote control
Press the middle of the side function switch on the TV in
HDMI input
PLEASE ENSURE BOTH UNITS ARE SWITCHED OFF BEFORE CONNECTING. Use a HDMI to HDMI cable to connect the two units together. To select the HDMI input, press the Source button on the remote control. Each time it is pressed the on-screen menu confirms your selection.
Auto Setup procedure
When the TV is operated for the first time, installation wizard will guide you through the process. First, language selection screen will be displayed. Select the desired language and press OK. On the second screen set your country preference. Press OK to continue. You can activate Store Mode option in the next step. This option is intended only for store use. It is recommended to select Home Mode for home use.

About Selecting Broadcast Type
Digital Aerial: If this broadcast search option is turned on, the TV will search for digital terrestrial broadcasts after other initial settings are completed.
Digital Cable: If this broadcast search option is turned on, the TV will search for digital cable broadcasts after other initial settings are completed. A message will be displayed before starting to search asking if you want to perform cable network search. If you select Yes and press OK you can select Network or set values such as Frequency, Network ID and Search Step on the next screen. If you select No and press OK you can set Start Frequency, Stop Frequency and Search Step on the next screen. When finished, highlight Next and press OK button to continue.
Note: Searching duration will change depending on the selected Search Step. Satellite: If Satellite broadcast search option is turned on, the TV will search for digital satellite broadcasts after other initial settings are completed. Before satellite search is performed some settings should be made. Antenna Type menu will be displayed first. You can select Antenna Type as Direct, Single Satellite Cable or DiSEqC switch by using directional buttons.
Analogue: If this broadcast search option is turned on, the TV will search for analogue broadcasts after other initial settings are completed. After all the available stations are stored, Channels menu will be displayed. You can edit the channel list according to your preferences using the Edit tab options or press the Menu button to quit and watch TV.
Note: Do not turn off the TV while initializing first time installation.