VISUAL COMFORT S 5695 Calvino Large Linear Chandelier Instruction Manual

: June 9, 2024
: VISUAL COMFORT

Table of Contents

TOOLS REQUIRED (NOT INCLUDED):
ASSEMBLY INSTRUCTION
Read User Manual Online (PDF format)
Download This Manual (PDF format)

NOTICE

This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved.

TOOLS REQUIRED (NOT INCLUDED):

Phillips Screwdriver
Slip Joint Pliers
Drill
Slotted Screwdriver
Wire Strippers
Hammer
Wire Cutters
Pencil

ASSEMBLY INSTRUCTION

INSTRUCTION

Carefully remove all parts from the box. Place on a clean, soft surface.
Remove mounting plate (C) from canopy (F) by loosening collar rings (G).
Using the mounting plate (C) as a guide, line up with the junction box and mark anchor positions.
Using a drill bit slightly smaller than the anchor, drill holes in the marked positions. Install anchors (B) into the holes using hammer.
Install mounting plate (C) to junction box and secure with mounting screws (E), then secure wood screws (D) to anchors (B).
Feed fixture wires through bottom rods (J) and connect to fixture body (K). Repeat for middle rod (I), connecting to bottom rod (J).
Continue feeding fixture wires through collar rings (G), canopy (F) and top rods (H)
Holding fixture upright, slide collar rings (G) and canopy (F) down top rods (H) and rest on top of middle rods. Then connect top rods (H) to middle rods (I). Tighten set screw (O) using provided screwdriver (Q). (See diagram 1)
NOTE: Slide components down slowly to avoid damages.
Hang fixture mount (N) to mounting plate (C) and tighten set screws (P) using provided screwdriver (Q). (See diagram 2)
NOTICE
This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved.
Cut excess wires, being sure to leave enough to reach the junction box. Separate wires, and strip insulation on each 5/8”.
Connect fixture neutral wire (black) to the driver output neutral wire (black) using wire nut (A).
Connect fixture hot wire (red) to the driver output hot wire (red) using wire nut (A).
Connect supply ground wire (usually green or bare copper) around the green grounding screw (see diagram 3). Tighten.
NOTE: It is imperative that the fixture is grounded.
Connect driver input neutral wire (white) to the supply neutral wire (usually white) using wire nut (A)
Connect driver input hot wire (black) to the supply hot wire (usually black) using wire nut (A).
CAUTION: Do not reverse the hot and neutral connections.
Make sure all wire connections are tight, then carefully tuck into the junction box.
Install canopy (F) to mounting plate (C) and secure with collar rings (G) .
Thread shades (M) to sockets (L).
NOTE: Do not overtighten otherwise shade could become damaged.