HOFTRONIC 4409197 Stuart Solar Wall Light User Manual

HOFTRONIC 4409197 Stuart Solar Wall Light

IMPORTANT SAFETY DETAILS

1. This product must be installed by a qualified electrician in accordance with instructions provided and in compliance with recognised electrical and safety regulations relevant to the country it is being installed.
2. Please handle carefully, avoid rough handling and collision.
3. This product may NOT be installed by minors or people with a mental disability.
4. Please keep the surface of the solar panel clean, to make sure the product works at it’s best performance.
5. It is important to install the light in a location that receive full sunlight each day, away from the shade caused by trees, buildings etc. Shady locations will not allow the battery to be fully charged and will reduce the hours of night time light.
6. The performance of the solar light is dependent on the geographical location, weather conditions and seasonal sunlight availability. On cloudy days and during winter, the solar light will not receive as much direct sunlight, resulting in reduced brightness and reduced operating time. Select an outdoor location away from other light source at night such as street lights. It may cause the product not to turn on automatically at night.
7. Dispose the used battery properly! Do not dispose the battery in fire!

Note: To use it for the first time, please turn on the switch, then charge the solar product by placing it under direct sunshine for 5 to 8 hours. Then the light can work at its best performance. (since the battery may drain out over time, so we neet to charge the battery before using it for the first time).

PRODUCT FEATURES

1. Using solar power supply and LED lighting, the perfect combination, energy-saving, environmental
2. The light charge during the daytime and automatically turning on at night
3. Waterproof, weather resistant
4. Easy installation

DIRECTIONS FOR USE

1. Turn the switch to ON position by push the key pin into the ON/OFF key hole, the light starts to work automatically. During the day,
   when the environment light is larger than 100 lux, the built-in light sensor will cut off the power output and charge the battery by the power produced by solar panel. When the night falls, the environment light is lower than 100-10 lux, the light turns on automatically.

2. Working time : After the solar panel has charged in direct sunlight for 4-6 hours, the solar light can light up to 10-12 hours. The battery included is 3.2V 7000 mAh

3. Product maintenance: to ensure that the product works well, every 3 months need to clean the dust on the solar panels, so that the effeciency of solar panels is better.

4. The battery included is 3.2V 2000 mAh. Battery should be replaced after 2-3 years.

INSTALLATION

GROUND MOUNTED

1. Tighten the screw, fix the lamp head with the lamp pole.
2. Turn on the switch (if it hasn’t been turned on before).
3. Use the expansion screw to fix the lamp base onto the ground.
4. Installation completed, enjoy the light!

WALL MOUNTED

1. Install the mounting hardware as the picture.
2. Fasten the lamp base.
3. Turn on the switch (if it hasn’t been turned on before).
4. Installation completed, enjoy the light!

IMPORTANT

ONLY by turning on the swich of the solar light in dark environment shall activate it, please test it in complete dark environment or cover the solar panel entirelly. If it still fails to light up, leave it under direct sunlight for charging for 5-8 hours and test again.

1. Install the solar product in an area where it can get direct sunlight.
2. Turn the switch to “ON position.
3. Select an outdoor location away from other light source at night such as street lights. It may cause the product not to turn on automatically at night.
4. Duration of light depends on solar product’s level of sunshine exposure, geographical locations, weather conditions and the hours of daylight available.

INTENDED USE / APPLICATION

Product designed for the use in households and for other similar general applications.

MOUNTING

Technical changes reserved. Read the manual before mounting. Mounting should be performed by an appropriately qualified person. Any activities to be done with disconnected power supply. Exercise particular caution. Product has a protective contact/terminal. Failure to connect the protective lead may lead to electric shock. Mounting diagram: see pictures. Check for proper mechanical fastening and connection to electrical power prior to first use. The product can be connected to a supply network which meets energy quality standards as prescribed by law. To maintain the proper IP protection level, the right diameter of the power cable should be selected for the cable gland used in the product.

FUNCTIONAL CHARACTERISTICS
Product can only be used outdoors.

USAGE GUIDELINES / MAINTENANCE
Any maintenance work must be performed when the power supply is cut off and the product has cooled down. Clean only with soft and dry cloths. Do not use chemical detergents. Do not cover the product. Ensure free air access. Product may heat up to a higher temperature. Product can only be supplied by rated voltage or voltage within the range provided. It’s forbidden to use the product with damaged protective cover. Product must not be used in unfavourable conditions, e.g. dust, water, moisture, vibrations, explosive air atmosphere, fumes, or chemical fumes, etc. Non-demountable product. Not suitable for independent repairs.

ENVIRONMENTAL PROTECTION
Keep your environment clean. Segregation of post-packaging waste is recommended. This labelling indicates the requirement to selectively collect waste electronic and electrical equipment. Products labelled in this way must not be disposed of in the same way as other waste under the threat of a fine. These products may be harmful to the natural environment and health, and require a special form of recycling/neutralising. Products labelled in this way should be returned to a collection facility for waste electrical and electronic goods. Information on collection centres is provided by local authorities or sellers of such goods. Used items can also be returned to the seller when new product is purchased, in quantity no larger than the purchased item of the same type. The above rules regard the EU area. In the case of other countries, regulations in force in a given country must be applied. Contacting the distributor of our products in a given area is recommended.

COMMENTS / GUIDELINES
Failure to follow these instructions may result in e.g. fire, burns, electrical shock, physical injury and other material and non-material damage. For more information about Hoftronic products visit www.hoftronic.com. Hoftronic shall not be responsible for any damage resulting from the failure to follow these instructions. Hoftronic reserves the right to make changes in the manual – the current version can be downloaded at www.hoftronic.com.

DECLARATION OF CONFORMITY

DOCUMENTATION
This product has been manufactured and supplied in compliance with all relevant regulations and directives applicable to all member states of the European Union. The product complies with all applicable regulations and rules in the country of sale.
Formal documentation such as the declaration of conformity, the safety data sheet and the product test report is available upon request.

CE DECLARATION
The product complies with the following directives:

• LVD : 2014/35/EU
• EMC : 2014/30/EU
• RoHS : 2011/65/EU

The complete Declaration of Conformity Document (DOC) is available upon request.

Imported by HOF Trading B.V. Fahrenheitstraat 11, 6003 DC Weert , The Netherlands Made in P.R.C. www.hoftronic.com

References

• HOFTRONIC - HOFTRONIC

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>