CK Purple Premium Smart Base Installation Guide
- May 15, 2024
- Purple
Table of Contents
CK/King Installation Guide
Purple Premium Smart Base
CK Purple Premium Smart Base
View set-up video here: https://purple.com/blog/how-set-up-your-purple-smart-
base This video demonstrates helpful hinge movements to correctly align the
long bolts.
Before discarding the packing materials, ensure all the parts are accounted
for. Some parts may be attached to the base or inside boxes. Please inspect
carefully.
Parts List
STEP 1- Unfold the base
Always use two people when setting up, moving or flipping base.
Unfold the base so that the bottom side is facing up.
STEP 2 – Secure hinge with short
bolt
a. Lift the frame slightly and insert a short bolt through the hole in the
hinge of the frame. (Refer to the blue indicators in Fig.A) b. Secure the end
of the short bolt with a washer and a nut. c. Finger-tighten the bolts first
to allow for bolt alignment on both sides before tightening the bolts with the
provided open end wrenches. STEP 3 – Secure hinge with long bolt
a. Lift the frame slightly and insert a long bolt through the hole in the
middle of the hinge of the frame.
(Refer to the red indicators in Fig.A) b. Secure the end of the long bolt with
a washer and a nut. c. If the bolt holes are not aligning, there are two hinge
movements that need to be adjusted. Adjust both directions while inserting the
bolt to find alignment.
d. Tighten the bolts with the open end wrenches provided.
STEP 4 – Screw in the legs
Attach legs by screwing them into leg threads. Do this on all four corners and
on each side in the middle. Note that alternative leg heights of 3” increments
may be achieved by unscrewing the leg segments.
STEP 5 – Flip the base
Carefully flip base over onto its legs.
Important: Two people are required to move bed base. Do not drag frame across the floor or rest frame on its side, as excessive pressure may damage legs.
STEP 6 – Install the mattress retainer bar
Insert each end of the mattress retainer bar into the holes located on the foot section, and lay it down so that it rests on the edge of the base.
V003_07/2023