FIAMMA Vent 28 F Roof Light Installation Guide
- June 9, 2024
- FIAMMA
Table of Contents
Rooflight
Installation and usage instructions
VENT 28 F
h 54-68 mm
Package contents
Check that nothing has been damaged or deformed during transport.
In the event of doubts or questions concerning the installation, use or
limitations of the product, contact the dealer. We recommend that the
installation is carried out by qualifi ed personnel and in compliance with
current local regulations.
-
Decide where the roofl ight should be installed and make a square hole of 28cm.
The rooflight can be installed on roofs with thickness between 54 and 68mm. -
Seal the lower part of the external frame with a minimum width of 10 mm by following the appropriate rails. Recommended sealant: SIKALASTOMER-710 / THEROSTAT II / DEKALIN 1512.
-
Place the external frame in the opening hole making sure that the hinges are facing the front of the vehicle.
-
Place the inner frame and proceed with the installation of the roofl ight using the 4 supplied screws.
Tighten the screws in order to bring the frame adherent to the roof, check that the frame hasn’t been deformed. -
Mount the mosquito net frame using the special pressure hooks.
Installation instructions
Remove the protective plastic applied to the cover (do not expose the product to sunlight for too long to avoid to make this operation diffi cult).
In case of problems please contact your local dealer indicating the data on the nameplate.
Safety instructions
Fiamma declines all responsibility for any personal injury and damage to
property due to incorrect assembly or use of the product; it is suggested to
keep the instructions inside the vehicle.
The assembly of the product must be carried out according to the assembly
instructions: the product must not be modifi ed in any way.
Before proceeding with assembly, check that the roof thickness is compatible
with the product.
Before choosing the place where to assembly the roofl ight, check that:
– the product doesn’t interfere with adjacent accessories (luggage racks,
cables, reinforcements in the roof, cabinets inside the passenger
compartment).
– the internal and external surface of the roof is flat.
Periodically check the tightness of all the screws in the roofl ight,
especially after the fi rst kilometres from the installation and always before
and after long trips. If the opening-closing device hardens, lubricate the
lid opening device with a few drops of grease. It is forbidden to walk on the
product cover.
Before starting the vehicle, check that the rooflight is properly closed.
Periodically check that the cover is intact. Don’t open the roofl ight when the
vehicle is travelling. Don’t open the roofl ight in case of strong wind or
rain. Remove snow or ice from the rooflight. Always comply with speed limits
and the Highway Code. The speed should always be suitable to traffic conditions
and transported load.
CARE AND MAINTENANCE:
For the internal and external cleaning of the roofl ight, always use only
neutral, non-aggressive detergents. For cleaning the Crystal cover use an
acrylic glass cleaner with a soft cloth so as not to scratch the surface.
Never use aggressive products such as glass cleaners, all-purpose cleaners,
abrasives or dish-washing detergents.
Also, never use alcohol-containing detergents, solvents or any corrosive
liquid. The mosquito net can be cleaned with water and a neutral detergent by
removing it from the press fittings.
Warranty
Warranty Fiamma. In case of defects with regards to materials and manufacturing, the customer is entitled to the warranty in accordance with local laws and regulations of the country in which the product was purchased.
Fiamma S.p.A. – Italy
Via San Rocco, 56
21010 Cardano al Campo (VA)
All rights reserved.
Fiamma S.p.A.
reserves the right to modify at any time,
without notice, prices, materials, specifi cations and models or to cease
production of any model.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>