DIEHL IZAR RDC Motion Installation Guide
- June 9, 2024
- DIEHL
Table of Contents
DIEHL IZAR RDC Motion
Package Content
Operating Instructions
Max. operation level 2000m above sea level
Only the following must be used:
Walk-by-Antenna :
868 MHz: Procom FLX 400/900-SMA (140000214 – factory calibrated)
434 MHz: Lynx ANT-433-CW-QW-SMA
Car-Antenna: Procom
MM Magnet holder without cable (30000351)
4m FME Cable (130000466)
FME-SMA Adapter (130000577)
868 MHz antenna: MU 906-X/I Emitter (130000275)
434 MHz antenna: MU 4-X/CEL3 Emitter (130000167)
Radio frequencies
wMBus:
868.950 MHz (uplink) / 869.525 MHz (downlink)
Max. Transmission power 500 mW (downlink)
or
434.475 MHz (uplink) / 433.500 MHz (downlink)
Max. Transmission power 10 mW (downlink)
Bluetooth:
2.4 GHz, version 4,1, class 1.5
Max. Transmission power 10 mW (downlink)
In case of reception issues upon short distances between device and meter, increase the distance between the receiver and the meter.
The device must be charged immediately upon receipt.
Only the following chargers should be used:
- Sunny SYS1561-1105-W2E 5C USB-C *
- Ammann In-Car Charger 130Q (1000-0024)
*Use the Sunny main supply charger only between 0°C and +45°C!
When stored, make sure to recharge battery minimum every ½ year to avoid loss of performance.
LED | Color | Operation |
---|---|---|
BT Bluetooth | Blue | Blue blinking: BT pairing possible |
Blue: BT is connected
wMBus| Green
Red| Short green flashing: wMBus message received
Short red flashing: message is being sent
Status| Green
Red
Yellow| Red: device is switched off, charging
Red blinking: device is switched off and shows charging error
Yellow: device is switched on and charging active
Green/yellow blinking: device switched on and charging error
Green: device is switched on, charging inactive
| Open Source Software Notice
This product contains open source software components. The use and
distribution of any open source software is governed by respective terms and
conditions of the applicable open source license. By using this product, you
acknowledge that you have reviewed such license terms and notices, and you
agree to be obliged by these terms.
Please insure that you get yourself familiar with the licenses terms and
conditions before using this product. The complete OSS manifest as well as
corresponding license terms are made available through third-party software
notice document which can be obtained from the download center on Diehl
Metering website: https://www.diehl.com/metering/en/supportcenter/download-
center/
If you have any questions regarding open source software used in this product,
please contact Diehl Metering support: oss-dmde@diehl.com
---|---
Simplified EU-/UK Declaration of Conformity
Hereby, Diehl Metering declares that the radio equipment type IZAR RDC MOTION
is in compliance with
Directive 2014/53/EU and the Radio Equipement Regulations 2017.
The full text of the EU and UK declarations of conformity is available at the
following internet address:
https://www.diehl.com/metering/en/support-center/download-center/
References
- Welcome to Diehl Metering | Diehl Metering
- Download Center | Diehl Metering
- Download Center | Diehl Metering
- Download Center | Diehl Metering
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>