Vossloh Schwabe 186973 Blu2Light PrimeLine DIP Switch UIT User Manual

June 9, 2024
Vossloh Schwabe

Vossloh-Schwabe-logo

Vossloh Schwabe 186973 Blu2Light PrimeLine DIP Switch UIT

Safety notes

The Blu2Light products may only be installed and commissioned by authorised specialists. Read these instructions carefully before installing and commissioning the system. This is the only way to ensure safe and correct handling. Keep this manual in a safe place so that it may be available at a later date. Before any work is carried out on the equipment, it must be disconnected from the supply voltage. The applicable safety and accident prevention regulations must be observed. Improper opening of the products is not permitted, there is a danger to life due to electrical voltage. Repairs may only be carried out by the manufacturer. In the event of incorrect connection or reverse polarity, the device and the connected LEDs may be damaged or destroyed!

Bluetooth® wireless technology

The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and any use of such marks by Vossloh-Schwabe is under license. Other trademarks and trade names are those of their respective owners. We, Vossloh-Schwabe Deutschland GmbH, hereby confirm that these devices only comply with the basic requirements of Directive 2014/53/ EU and other relevant directives. The entire text of the declaration of conformity can be obtained from the following address: www.vossloh- schwabe.com

Assembly

  • The Blu2Light driver is intended to operate LED luminaires (e.g. spots).
  • First, connect the luminaires (e.g. spots) to the outputs of the drivers (sec.) to.
  • Then connect the power supply to the module.
  • The input side must be connected to mains voltage, 220-240 V AC.

Installation instructions

  • Pay attention to the correct polarity at the output: + and –

Setup and operation

  • The Blu2Light devices are configured with the LiNA Connect app and can be operated via the LiNA Touch app.
  • For the exact procedure for the configuration of the devices please refer to the instructions in the LiNA Connect app or in the corresponding documentation.
  • A tablet is required for setup, both tablets and smartphones can be used for operation. Both are not included in the scope of delivery.
  • For information on the iOS and Android operating systems that can currently be used, refer to the LiNA Connect/ LiNA Touch manual:Vossloh-Schwabe-186973-Blu2Light-PrimeLine-DIP-Switch-UIT-fig-1

Important note
Please refer to the installation instructions included with the product and the applicable Blu2Light system data sheet „How to Blu2Light“ before installation. Make sure that the Bluetooth radio signal can propagate freely according to the specifications.

Technical Notes

Ref.-No. Blu2Light PrimeLine DIP switch UIT 325: 186973, 186974

  • Communication: Blu2Light mesh network
  • Frequency range: 2402–2480 MHz
  • Output power: < 10 mW EIRP
  • Mains voltage: 220–240 V AC
  • Power consumption standby/operation: 0.5 W / 30 W
  • Ambient temperature: -20–35 °C
  • Protection class: IP20
  • Protection class II
  • Dimensions with cord grip: 325 x 34 x 36.6 mm (LxWxH)
  • Housing: plastics, black/white
  • Weight : 126 g
  • Push-in terminals for cross-section: primary 0.75 mm² / secondary: 0.5–1.5 mm²
  • Min. dim level: 1.5 % from the maximum current (analog)

Ref.-No. Blu2Light PrimeLine DIP switch UIT 325: 186975, 186976

  • Communication: Blu2Light mesh network
  • Frequency range : 2402–2480 MHz
  • Output power: < 10 mW EIRP
  • Mains voltage : 220–240 V AC
  • Power consumption stand-by / operation: 0.5 W / 45 W
  • Ambient temperature ta: -20–35 °C
  • Protection class: IP20
  • Protection class II
  • Dimensions with cord grip: 345 x 34 x 36.6 mm (LxWxH)
  • Housing: plastics, black / white
  • Weight: 143 g
  • Push-in terminals for cross section: primary 0.75 mm² / secondary: 0.5–1.5 mm²
  • Min. dim level: 1.5 % from the maximum current (analog)
    607637-00V2

Principle wiring diagram

Vossloh-Schwabe-186973-Blu2Light-PrimeLine-DIP-
Switch-UIT-fig-2

Suitable for:

  • Eco
  • EU Track
  • Globaltrack
  • Iguzzini
  • Zumtobel

Service

Vossloh-Schwabe Deutschland GmbH
Stuttgarter Straße 61/1
73614 Schorndorf, Germany
Phone: +49 (0)7181 8002-0
info.vsv@vossloh-schwabe.com
For further information please visit our website: www.vossloh- schwabe.com

References

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals