My Green Lighting Floor Light Instruction Manual
- June 9, 2024
- My Green Lighting
Table of Contents
My Green Lighting Floor Light
Safety Warnings
- These instructions are for your safety. Please read through them thoroughly before use and retain them for future reference. If you are in any doubt about installing this product, consult a qualified electrician.
- This product is only suitable for connection to a 220-240V~ 50Hz supply. It is for indoor use only, and not suitable for a bathroom location.
- This fitting is a Class II, Double Insulated product and does not require an Earth. Live or Neutral must not be connected to Earth.
- Do not attempt to plug in or use this product until it has been fully assembled. Disconnect from mains during assembly or maintenance. this product must be used on a stable, flat surface.
- Under no circumstances must this floor lamp be covered with any material as this could pose a safety hazard.
- This product is not suitable for persons under 14 years of age.
- If the external flexible cable or cord of this luminaire is damaged, it must only be replaced by a qualified electrician to avoid any electrical hazards.
- The lamp must be protected by a 3 amp fuse in the mains plug.
- Never put anything on the product or hang anything on any part of this product.
- This product may contain delicate parts – be careful during handling and maintenance to avoid breakage.
- Never fit bulbs of a higher wattage than those specified on the label as these may damage the fitting.
- Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
- Check with your Local Authority or local store for recycling advice.
Care and maintenance
For bulb replacement, switch off the product (preferably, isolate it at the
distribution board) and allow it to cool down (Caution: bulb gets hot during
use).
Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this
product.
Troubleshooting
When the bulb does not light after installation:
-
Please plug in and operate the switch to turn your lamp on.
-
Please check the bulb.
-
Please check the 3 amp fuse in the plug and ultimately check the relevant fuse in your fuse box.
If you have any doubt about installation/use of this product, consult a qualified electrician.
To use this item in Europe, the 3 pin adaptor can be removed by loosening the central screw and removing the adaptor to reveal the 2 pin Europe plug.
Assembly Instructions
- Fit the desired bulb (sold separately), taking note not to exceed the wattage on the bulb holder label.
- Place your lamp in a suitable location, plug in and ensure the cable is not strained or create a trip hazard. Your lamp is now ready for use.
- The height of the light can be adjusted by unscrewing the knurled cuff, raising the lamp head and re-tightening the cuff. The orientation of the lamp can be adjusted by manipulating the swing arm. Please ensure you keep one hand on the base or stem at all times while moving to prevent the lamp from tipping. When adjusting the lamp angle, please ensure you use the handle, as the lamp head may become hot during use.
UK Manufacturer: BH17 7BY
EU Manufacturer: Brilliant AG,
Brilliantstrasse 1, D-27442 Gnarrenburg
Scan QR code for multi-language:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>