My Green Lighting 96931 Outdoor IP44 Portable Table Light Instruction Manual
- June 6, 2024
- My Green Lighting
Table of Contents
Installation and Safety Instructions Table Light
Safety Warnings
These instructions are for your safety. Please read through them thoroughly
before use and retain them for future reference. If you are in any doubt about
installing this product, consult a qualified electrician.
This product is rated IP44( definition e.g. splash proof/rain proof etc).
Ensure that the screws and cable entry points are sealed to maintain the IP
rating of the product.
Under no circumstances must this lamp be covered with any material as this
could pose a safety hazard. This product is not suitable for persons under 14
years of age.
The battery must not be opened, destroyed or incinerated. In the unlikely
event that the battery needs replacing – only use a battery of the same type
and specification.
The solar panel has an integrated daylight sensor -enabling the light to come
on at dusk and switch off at dawn. Ensure the product is located in a sunny
position to ensure effective recharging of the battery.
To test the light and check if it is switched on, cover the solar panel and
the light should operate. Initial charging for 1-2 days may be necessary.
This product may contain delicate parts be careful during handling and
maintenance to avoid breakage.
This is a touch lamp ON/OFF, touch the button to turn on. Touch again to make
it brighter, brightest, and then off again.
Never put anything on the product or hang anything on any part of this
product.
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist Check with your Local Authority or local
store for recycling advice.
Care and maintenance
Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this product.
Troubleshooting
If you have any doubt about installation/use of this product, consult a qualified electrician.
Assembly Instructions
This product can also be charged using the supplied USB cable. Please note – this cable is for charging the product, not to charge other items.
| NOTE – This product will only illuminate at dusk. It will not be able
to be operated during daylight. Press and hold the switch for 3
seconds to turn on, the product will stay on at 20Lm
---|---
| After mode 1, touch the switch make it brighter, the product
will stay on at 90Lm
| After mode 2, touch the switch make it brighter, the product
will stay on at 230Lm
| Press and hold the switch for 3 seconds to turn if off.
Solar Charge Time – 13-15hrs USB Charge Time – 6-7hrs Functional Time – 8-9hrs.
Battery Replacement
Scan QR code for multi-language
UK Manufacturer: BH17 7BY
EU Manufacturer: 1 Gnarrenburg, 27442
96931_20210719
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>