vtech 80-559200 Switch and Go Hatch and Roaaar Egg Velociraptor Racer Instruction Manual

vtech 80-559200 Switch and Go Hatch and Roaaar Egg Velociraptor Racer

INTRODUCTION

Thank you for purchasing Switch & Go® Hatch & Roaaar Egg
Velociraptor RacerTM!
Assemble this powerful Velociraptor, then transform it in a few simple steps in to a revved-up race car! Add dino roars and cool engine sound effects along with flashing lights. Stomp, chomp and roar!

INCLUDED IN THE PACKAGE

• Switch & Go® Hatch & Roaaar Egg Velociraptor RacerTM
• 15 Pieces for Assembly
• Quick Start Guide

WARNING: All packing materials such as tape, plastic sheets, packaging locks, removable tags, cable ties, cords and packaging screws are not part of this toy, and should be discarded for your child’s safety.
NOTE: Please save this manual as it contains important information.

Unlock the Packaging Locks

1. Turn the packaging lock counterclockwise several times.
2. Pull out the packaging lock and discard.

GETTING STARTED

Exit Try-Me Mode
The product is in Try Me mode in the packaging. To exit try-me mode, just slide the “Off/Dino Mode/Vehicle Mode” Switch from Vehicle mode to Dino mode/Off.

Battery Removal   and Installation

1. Make sure the unit is turned Off.
2. Find the battery cover located on the bottom of the unit, use a screwdriver to loosen the screw, and then open the battery cover.
3. Remove the old battery by pulling up on one end of the battery.
4. Install 1 new AAA (AM-4/LR03) battery following the diagram inside the battery box. (For best performance, alkaline batteries or fully charged Ni-MH rechargeable batteries are recommended.)
5. Replace the battery cover and tighten the screw to secure.

WARNING: Adult assembly required for battery installation. Keep batteries out of reach of children.

IMPORTANT: BATTERY INFORMATION

• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in fire. RECHARGEABLE BATTERIES
• Remove rechargeable batteries (if removable) from the toy before charging.
• Rechargeable batteries are only to be charged under adult supervision.
• Do not charge non-rechargeable batteries.

ASSEMBLY INSTRUCTIONS

1. Identify the following pieces for assembly:
2. Separately install the A, B, C, D, E, F, G and H parts as shown in the illustrations.

TRANSFORMATION

1. Begin in Dino mode.
2. Close the Dino’s mouth, then flip up the front claws. Next, swing up the Dino’s legs.
3. Flip the feet in toward the Dino’s head..
4. The Dino is now changed into a Vehicle. Slide the Off/Dino mode/Vehicle mode Switch to Vehicle mode to play Vehicle responses.

Note:  To switch from Vehicle mode to Dino mode, follow the above steps in reverse order.

PRODUCT FEATURES

1. OFF / DINO MODE / VEHICLE MODE SWITCH
   Slide the Off / Dino Mode / Vehicle Mode Switch to turn the unit On and choose Dino mode or Vehicle mode to play. Slide the Off / Dino Mode / Vehicle Mode Switch to the Off position to turn the unit Off.

2. Talk Button
   Press the Talk Button to hear fun phrases and cool dinosaur sounds in Dino mode, or hear fun phrases and great vehicle sounds in Vehicle mode.

3. Automatic Shut-Off
   To preserve battery life, Switch & Go® Hatch & Roaaar Egg T- Rex RacerTM will automatically shut off after approximately a few seconds without input. The unit can be turned on again by pressing the Talk Button or by switching between Dino and Vehicle modes.

Note:  If the unit powers down or if the light flashes 3 times without sounds during play, please install a new set of batteries.

CARE & MAINTENANCE

1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct heat sources.
3. Remove the batteries if the unit will not be in use for an extended period of time.
4. Do not drop the unit on hard surfaces and do not expose the unit to moisture or water.

TROUBLESHOOTING

If for some reason the unit stops working or malfunctions, please follow these steps:

1. Turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit On. The unit should now be ready to use again.
5. If the unit still does not work, replace with a new set of batteries.

IMPORTANT NOTE
If the problem persists, please call our Consumer Services Department at 1-800-521-2010 in the U.S.,1-877-352-8697 in Canada, or visit our website vtechkids.com and fill out our Contact Us form located under the Customer Support link. Creating and developing VTech products is accompanied by a responsibility that we take very seriously. We make every effort to ensure the accuracy of the information, which forms the value of our products. However, errors sometimes can occur. It is important for you to know that we stand behind our products and encourage you to contact us with any problems and/or suggestions you might have. A service representative will be happy to help you.

NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Supplier’s Declaration of Conformity 47 CFR § 2.1077 Compliance

Information

• Trade Name: VTech®
• Model: 5591
• Product Name: Switch & Go® Hatch & Roaaar Egg Velociraptor RacerTM
• Responsible Party: VTech Electronics North America, L.L.C.
• Address: 1156 W. Shure Drive, Suite 200 Arlington Heights, IL 60004
• Website: vtechkids.com

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
CAN ICES-003(B)/NMB-003(B)

WARNING:  CHOKING HAZARD—Small parts. Not for children under 3 yrs.

Visit our website for more information about our products, downloads, resources and more.
vtechkids.com
Read our complete warranty policy online at
vtechkids.com/warranty

References

• VTech Canada | Official Electronic Learning Toys & Games for Kids
• VTech Canada | Official Electronic Learning Toys & Games for Kids
• Best Kids Tech Toys | Electronic Learning Toys | VTech America
• Best Kids Tech Toys | Electronic Learning Toys | VTech America

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>